Fusion 25744 User manual

SOLAR FENCE
POST LIGHT
model no. 25744
ASSEMBLY INSTRUCTIONS
IMPORTANT: Please read this manual
carefully before beginning assembly of this
product.
Keep this manual for future reference.
Overview
This product is designed to the highest technical specifications and standards. It will supply years of
maintenance-free use. Please read these instructions thoroughly prior to installation, then store in a safe place
for future reference.
About Your Solar Light
During the day your solar panel will convert the sun’s light and/or UV rays into electrical power that will charge
the rechargeable battery. When it becomes dark, the solar light will turn on using the power stored in the
rechargeable battery as it will detect no daylight. The unit’s light output strength and duration depends on how
many hours and how much sunlight and/or UV rays your panel absorbs throughout the day.
For maximum output place the solar panel in an area where there is direct sunlight for at least 8 hours in a
given day. Do not install your solar light in a shaded area. The selected location should not be near nighttime
light sources such as porch lights, street lights or pool lights, as these may cause the solar light to turn off
prematurely.

2
Getting Started
Please do not throw away any packing material until all parts are
verified as present.
Parts List
IMPORTANT INFORMATIONASSEMBLY AND OPERATION
Use and
Care Guide - 1
Screws - 2
Solar Fence
Post Light - 1
model no. 25744
Important
• Fully charge the battery before first use.
• For best results, locate your solar lamp in a position where it can get direct sunlight on the solar panel and is
generally free from cover and shade.
• Keep your solar lights away from other nighttime light sources, such as streetlights.
• Make sure the solar panels are not covered by dust, snow and debris. Clean it with a soft damp cloth or paper
towel periodically. Avoid the use of abrasive cleaning agents.
• Use only rechargeable batteries for your solar lights. Replace with a new battery of the same size each year for
optimum performance.
Assembly & Operation
For First Time Use:
Step 1: While holding the base of the light, turn the solar
housing in a counter clockwise direction to remove
(Figure 1).
Step 2: Remove the pull tab from the battery compartment.
Step 3: Fully charge the battery before first use. Charge
under direct sunlight for 2 days. Once fully
charged, your solar light will automatically turn on
once it gets dark.
Figure 1
Rechargeable
Battery - 1

3
Installation
Step 1: Place post cap onto post and mark holes (2)
for screws as required.
Step 2: Remove fixture temporarily and pre-drill holes
if necessary.
Step 3: Replace fixture onto post and secure with
provided screws in both locations.
Battery Replacement
Step 1: Remove the solar housing from the base by
turning in a counter clockwise direction (Figure 1).
Step 2: Remove the battery compartment cover. Carefully
remove the old battery.
Step 3: Replace battery with an equivalent new solar
rechargeable battery, ensuring the correct polarity
is observed.
Step 4: Reassemble the unit by reversing the above
procedure.
Step 5: Fully charge the battery before first use. Charge
under direct sunlight for 2 days. Once fully
charged, your solar light will automatically turn on
once it gets dark.
CAUTION: Rechargeable batteries contain nickel-cadmium
or nickel-metal hydride and must be recycled or disposed
of properly. Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable batteries.
Do not dispose of batteries in fire. Batteries may explode or
leak.
INSTALLATIONBATTERY REPLACEMENT

4model no. 25744
Troubleshooting Tips
If your solar light does not come on at dusk despite following all instructions please try the following steps:
1. Make sure that the solar light is not affected by any other light source.
2. Ensure the solar light does not stand in the shade all day.
3. Check to see if the batteries are installed correctly.
4. Battery may need to be replaced.
Care Information
1. Clean any dirt and debris from the solar panel. The panel cannot recharge if the light is obstructed. Use a soft
cloth to clean the panel. Do not use abrasives or chemicals that might scratch or damage the UV coating.
2. In a region where snow and ice are likely and the light assembly is covered with snow for an extended period of
time the batteries will require a recharge for at least 8 hours.
3. To prolong the life of the product, it is recommended to store the product indoors during the winter months.
Remove the batteries and store in a dry location.
1-Year Limited Product Warranty
This product is covered under a one year limited warranty. Fusion Products Ltd. warrants to the original purchaser
that this product is free from defects in materials and workmanship for the period of one year warranty from date
of purchase.
For Technical Support and/or Warranty inquiries please contact:
Fusion Products Ltd.
Monday to Friday
8:00-4:00 PM EST
5 Cherry Blossom Road, Unit 7
Cambridge, Ontario N3H 4R7
Tel: [phone] Fax: [phone]
Email: [e-mail]
Website: www.fusionproducts.ca
MAINTENANCE
WARRANTY