Fuslon 24513 User manual

SOLAR
CERAMIC POT
User Manual for
Models: 24513, 24515
OVERVIEW
This product is designed to the highest technical specifications and
standards. It will supply years of maintenance free use. Please read
these instructions thoroughly prior to installation, then store in a
safe place for future reference. If at any time you are unclear about
this product, or require further assistance please do not hesitate to
contact our trained professionals operating the customer support
line at 1-877-615-1378 Monday to Friday between the hours 8:30
AM to 5:00 PM Eastern Standard Time or email
[email protected]
GETTING STARTED
Please do not throw away any packing material until all parts are
verified as present.
ABOUT YOUR SOLAR LIGHT
During the day your solar panel will convert the sun's light and/or
UV rays into electrical power that will charge the rechargeable
battery. When it becomes dark, the solar light will turn on using
the power stored on the rechargeable battery as it will detect no
daylight. The units light output strength and time depends on how
many hours and how much sunlight and/or UV rays your panel
absorbs throughout the day.
For maximum output place the solar panel in an area where there
is direct sunlight for at least 8 hours in a given day. Do not install
your solar light in a shaded area. The selected location should not
be near night time light sources such as; porch lights, street lights
or pool lights as these may cause the solar light to turn off
prematurely.
IMPORTANT
•Fully charge the battery before first use.
•For best results, locate your solar lamp in a position where it
can get direct sunlight on the solar panel and generally free
from cover and shade.
•Keep your solar lights away from other night-time light
sources, such as streetlights.
•Make sure the solar panels are not covered by dust, snow and
debris. Clean it with a soft damp cloth or paper towel
periodically. Avoid the use of abrasive cleaning agents.
•Use only rechargeable batteries for your solar lights. Replace
with a new battery of the same size each year for optimum
performance.
OPERATION
FOR FIRST TIME USE:
Step 1:
Fully charge the battery before first
use. Charge under direct sunlight in
the <OFF> position for 2 days.
Step 2:
Carefully remove the lid/solar housing from
the lantern (Figure 1).
Step 3:
For daily operation, place the ON/OFF
switch in the <ON> position under the solar
housing. Your solar light will automatically
turn on once it gets dark.
CHANGING THE BATTERY
Step 1:
Carefully remove the lid/solar housing
from the lantern (Figure 1).
Step 2:
Push the switch to the <OFF> position.
Step 3:
Remove the battery compartment cover
(Figure 2).
Step 4:
Carefully remove the old battery
(Figure 3).
Step 5:
Replace the battery with an equivalent
new solar rechargeable battery; ensuring
the correct polarity is observed.
Step 6:
Reassemble the unit by reversing the
above procedure.
Caution: Rechargeable batteries contain Nickel-Cadmium or Nickel-
Metal Hydride and must be recycled or disposed of properly. Do not
mix old and new batteries. Do not mix alkaline, standard (carbon-
zinc), or rechargeable batteries. Do not dispose of batteries in fire.
Batteries may explode or leak.
TROUBLE SHOOTING TIPS
If your solar light does not come on at dusk despite following all
instructions please try the following steps:
1. Make sure that the solar light is not affected by any other light
source.
2. Ensure the solar light does not stand in the shade all day.
3. Check to see if the batteries are installed correctly.
4. If there is a protective film on the solar panel remove it.
CARE INFORMATION
1. Clean any dirt and debris from the solar panel. The panel cannot
recharge if the light is obstructed. Use a soft cloth to clean the
panel. Do not use abrasives or chemicals that might scratch or
damage the UV coating.
2. In a region where snow and ice are likely and the light assembly
is covered with snow for an extended period of time the batteries
will require a recharge for at least 8 hours.
1-YEAR LIMITED PRODUCT WARRANTY
This product is covered under a one year limited warranty. Fusion
Products Ltd. warrants to the original purchaser that this product
is free from defects in materials and workmanship for the period
of one year warranty from date of purchase.
For Technical Support and/or Warranty inquiries please
contact: Fusion Products Ltd.
Monday to Friday
8:30-5:00 PM EST
2905 Argentia Road, Unit 2,3
Mississauga, Ontario L5N 8G6
Tel: [phone]
Fax: [phone]
Email: [email protected]
Figure 1
Figure 2
Figure 3
Figure 3