9 |
Complete drain and storage
Please note - all condensed water must be
drained prior to relocation or storage.
Unplug the unit from the mains.
Place the unit over a drain or a water tray /
container. Remove the water bung from the
bottom of the unit. When water no longer falls,
replace the bung.
When the unit is not in
use, tidy the power cord
away as shown.
Clean or change the lter. On a warm day, turn the unit to ventilation mode for a couple of hours
so that the inside can dry out completely.
It is recommended that the unit be put back into its original carton for storage. Do not stack heavy
objects on top of the unit.
Disconnecting the indoor and outdoor unit
If the indoor unit needs to be disconnected from the
outdoor unit, to place it in a more suitable position,
follow these steps:
Disconnecting
• open the tube connection box [11] situated
at the back of the indoor unit.
• disconnect the connection tube to unit
securing strap [12]
• disconnect the drain tube [C].
• disconnect the electrical cable [A].
• disconnect the refrigerant tubes [B] using
the spanners [15] provided.
The terminals are tted with automatic self-
sealing valves to prevent the gas from leaking.
Loosen the nuts quickly, so the seal is made
promptly.
During the operation take extreme care not to
break the refrigerant tubes.
• cap the terminals with the caps [17]
provided to protect them from dust.
Mount the outdoor unit on the bracket as
describeb on page 5.
Connecting
• pass the connection tube through the hole
(at least dia. 50 mm) if present.
• remove the protection caps (if used
previously).
• reconnect the refrigerant tubes (tighten the
nuts quickly to make a good seal), the drain
tube and the electrical cable.
• close the connection box on the indoor unit.
GB
