Futlight Optoelectronics FUT22C000 User manual

2.4G Color Temperature and Brightness Adjusting LED Touching Remote
Control System
Instruction for FUT22C000

I .Product Description
This system is a high-performance color temperature adjustable LED touching
remote controller, adopting the most advanced PWM control technology. To
achieve the effect of color temperature change by adjusting two groups of LED
light proportion.The system owns 20 grades of brightness and 11 grades of
color temperature.
It is also with the memory function(means the previous settings will be
resumed when power on again). Widely used in color temperature and
brightness adjustable LED strip lights, LED modules and other LED products.
Owing to the 2.4G high RF wireless remote control technology, it has the
characteristics of low power consumption, long distance remote, and strong
anti-interference ability ,high speed telecommunications, etc.
The remote looks fashionable, with simple and practical functions of color
temperature and brightness dimming, the capacitive touch screen design
makes the remote easy to use .
The modular design and easy screwed terminals enable the controller easy to
match with all kinds of LED lights.
II. Technical Parameters
III.Functions of Keys
Item
Parameters
Remote
Working Voltage
AAA*2pcs(3V)
Radio Frequency
2400-2483.5MHz
Modulate Method
GFSK
Transmit Power
6db
Standby Power Consumption
5uA
Remote Distance
20-30m
Dimension
113×55×18mm
Controller
Working Voltage
DC12-24V
Max Load Control Current
6A/circuit
Standby Power Consumption
0.5W
Output Connection
Common anode
Dimension
85mm×45mm×22mm

IV.Programming(Code Clearing and Code Matching )
Code Matching
For a new kit ( remote& controller), the remote can work only when it is
programmed to the controller.
Please follow the below instructions:
Confirm correctly connect the power supply, LED controller and LED load.
Press key 1 once within 3 seconds when power on again,the light will blink 2
times when it is done.
Code Clearing
The code can be cleared as needed.
The kit (remote and controller) will stay in the original state after code
clearing,and it can work when code matching is done.
Please follow the below instructions:
Confirm correctly connect the power supply, LED controller and LED load.

Press key 1 five times within 3 seconds when power on again, the light will
blink 9 times when it is done.
Attention:
1.The regular product for sale is a kit (remote and controller).
The user can re-programme freely as needed. One remote can control
countless controllers, but one controller can only be controlled by four remotes
(Max).
2.Please check the battery installation and controller(totally discharge the
power), when you programme after switching off and switching on.
V. Connection:
VI. Attention
1.Please check whether the input voltage of the constant voltage power supply
is in accordance with the controller, and please check the connection of both
the cathode and anode, otherwise the controller will be broken.
2.Please do not connect wires with power on.Please switch on only when it is
in right connection and no short circuit.
3.Please keep your figure off the touching ring when installing the batteries, to
improve its sensitivity, and use the remote (3 seconds later) after the

installation.Please reinstall the batteries, if the touching ring is found
low-sensitivity.
4.Please do not use the controller in the place with widely range metal area or
strong electromagnetic wave nearby, otherwise, the remote distance will be
seriously affected.
Caution
1.Thanks for using color temperature and brightness adjustable LED touching
remote control system, please read the instruction carefully before using. It
states that you have read this instruction and accepted the caution when you
start to use.
2.Shenzhen Futlight Optoelectronics CO.,Ltd reserves the right of final
explanation and amendment to the products.