Gainsborough K244 User manual

Set 4 Bronze Lawn Edging with Solar
Lights
K244 v02: 17/01/22
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Allow lights to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ON position. The
ON/OFF switch is located under the solar panel. Once the batteries are fully charged, set the ON/OFF switch
to ON. If the lamp does not turn on after dark refer to Maintenance section.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
Parts
BEFORE FIRST USE: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set button (located underneath solar panel) to “ON” position. Charge the solar product by placing it
under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the daytime
and illuminate at night.
Always position in direct sunlight
Dimensions
(H) 34 x (W) 49 x (D) 2.2cm
•POLYSILICON SOLAR PANEL 2V 70MAH
•SOLAR PANEL STAKE –1M AWAY
•2 IN 1 CREATE A BORDER AND LIGHT UP THE
WALK WAY
•113CM WIRE BETWEEN EACH SECTION OF
BORDER
1 x 1.2V Ni-MH AA 400mah Rechargeable

Set 4 Bronze Lawn Edging with Solar Lights K244 Instructions for Use
Please read and retain these instructions for future reference v002:17/01/22
3. Set “ON/OFF” button to “ON”
position for steady on light, press the
“MODE” button to activate flash light
function. If you like to go back to
steady on light, then press “MODE”
button again to deactivate flash light.
NOTE: In order to verify that the button
is correctly in the “ON” position, cover
the solar panel with your hand and the
light should turn “ON” automatically.
TROUBLESHOOTING
Make sure the button is set to “ON” position and keep the solar panel clean. If solar product does not light
up after it has been used for around 8 –12 months, replace the rechargeable batteries as they may be weak
or worn out. (Battery 1pc “AA” 1.2V 300mAh, Ni-MH, Rechargeable–Same equivalent type as recommended
must be used).
BATTERY REPLACEMENT
Step1: Unscrew the battery compartment cover by using a Phillips
head screwdriver (not included).
Step2: Remove the exhausted battery and install 1pc new AA
rechargeable battery according to the +/- symbol polarity
indicated on the battery compartment. Open the compartment
carefully and ensure that welding wires inside the battery
terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into
position and ensure is properly sealed.
ASSEMBLY INSTRUCTIONS
To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden
stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first
then gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the
ornament housing containing the actual LED light.

Set 4 Bronze Lawn Edging with Solar Lights K244 Instructions for Use
Please read and retain these instructions for future reference v002:17/01/22
1. The bulbs and stakes need to be assembled first. Push the bulb into place then move onto the next
bulb. Affix total of 9 lights one after the other. Press each one down until it locks (see image). When all
bulbs are in place (36), fit the backing section and clip into place, press down to lock them. Make sure
it is clipped in place then turn the panel over and push the bulb in to place. Then move on to the next
panel.
2. Slide the stakes into the holes
3. Connect the panels.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. During the winter if you can bring it inside and give a good clean ready for next year.
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
Clip panels together and attach part C, D
and E at one end.
Panel open with lights clipped in place.
Panel with back cover fitted.

Set 4 Bronze Lawn Edging with Solar Lights K244 Instructions for Use
Please read and retain these instructions for future reference v002:17/01/22
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.
Code &
Symbol
Type of Plastic
Polypropylene
Commonly
used for
Microwaveable food containers, yoghurt pots, butter tubs, disposable plates and cups
Notes
Commonly recycled and collected from household recycling bins (packaging tape itself not
recyclable but does not interfere with cardboard)
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.