Gainsborough G+ HOME HUB User manual

G+ HOME HUB
User Guide

WELCOME TO
THE EASIER WAY
TO ACCESS
YOUR HOME

This guide will show you how to install your
G+ Home Hub.
G+ HOME HUB MOUNTING BRACKET
WHAT’S IN YOUR G+ HOME HUB BOX?
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Take care! Electricity kills. Switches, power outlets and other fixed wire
products must be installed by a licensed electrical contractor or similarly
qualified person.

CONTENTS
SECTION 1
Overview.................................................................................................................2
Applications 2
Non G+ Control Systems 3
Feedback 4
Layout .....................................................................................................................5
Communication overview...................................................................................7
SECTION 2
Installation .............................................................................................................9
Location 10
Mounting instructions 10
Wiring Instructions Guidelines 12
Setup......................................................................................................................17
Programming 17
SECTION 3
General Specifications .......................................................................................19

1
OVERVIEW, LAYOUT,
COMMUNICATION
OVERVIEW

2Section 1 Overview
Overview
The G+ Home Hub is an electrically powered device used within the
G+ Access System to enable non G+ Systems to control G+ Devices.
The G+ Home Hub is wired to a non G+ control system to:
• Receive input commands from the non G+ control system
• Send status of (receive feedback from) suitable G+ Devices to the
non G+ control system.
The G+ Home Hub controls G+ Devices via RF (Radio Frequency) link.
APPLICATIONS
G+ Devices a G+ Home Hub can control AND monitor include:
• 1 x Electric G+ Lockset
OR
• Up to 3 of any combination of the following:
– G+ Smart Boxes with feedback enabled -
Refer to the G+ Smart Box Installation Manual for more information
– G+ enabled Gliderol garage doors with feedback enabled.
Refer to the G+ Gliderol Garage Door Installation Manual for
more information
Additional devices a non G+ System could control via a
G+ Home Hub include:
• Battery G+ Lockset
• G+ Smart Boxes with feedback disabled.
There is no limit to the number of non-feedback G+ devices that can
be simultaneously operated by a single G+ Home Hub.

3Section 1 Overview
NON G+ CONTROL SYSTEMS
Examples of suitable* systems that could activate a G+ Home Hub
include:
• Home automation systems
• Building access systems
* A suitable system is one that activates the G+ Home Hub by a voltage free switch.
NOTE: The installer is responsible for ensuring the compatibility of systems
being connected to the G+ Home Hub.

4Section 1 Overview
FEEDBACK
The G+ Home Hub is capable of sending information about the status
of the device it is controlling to the non G+ Controller, if this information
exists. In this manual this information is referred to as feedback.
Examples of feedback include:
• From the Electric G+ Lockset
– Deadlock Mode
– Privacy Mode
– Passage Mode
– Door Closed
• From the G+ Smart Box
– Garage door up / down
– Alarm on / off
– Gate open / closed
– Lights on / off
Status feedback from the G+ Smart Box is only possible if appropriate
sensors are connected to the G+ Smart Box and feedback is enabled.
Refer to the G+ Smart Box User Guide for more information.
• For the G+ enabled Gliderol Garage Door
– Garage door up / down
The G+ Home Hub communicates feedback by switching its output.
NOTE: The Door Closed signal will indicate ‘door open’ if power is
disconnected to the Electric G+ Lockset.