Gajah GD88BT User manual

GD88BT Portable Speaker
With Bluetooth
Quick Start Guide

GD88BT Quick Start Guide
Fcc information
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
-------------------------------------------------------------------------------------------------------
----
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

GD88BT Quick Start Guide
Disclaimer
All the information, design and specifications contained in this manual were
correct at the time of publication. However, as the product is under
continuously upgrading, the final device may have a slightly difference in
appearance or modified functionality than presented in this manual.
Safety precautions
Never subject speaker to extremes of light, temperature, moisture or
vibration.
Do not use or store speaker in a location subject:
A. Extreme high temperature, such as in a sun-heated car
B. Direct sunlight
C. High humidity or places with corrosive substances
D. Sub-zero condition, especially during winter.
Clean only with a dry cloth.
Don’t block any of the ventilation openings, install according to the
manufacturer’s instructions.
Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way.
The symbol means that the unit complies with European safety and
electrical interference directives.

GD88BT Quick Start Guide
Parts and Control
Side View Top View
1. USB jack - for connecting to music source or emergency charging.
2. Line-in port - to connect to external audio device via 3.5mm audio
cable
3. Power button - Press and hold to turn thedevice on or off. Press once
briefly to play/pause audio playback when connected to Bluetooth
device.
4,5. +/- Volume button - Press and hold to adjust the volume level;
6. Pairing button- Press to enter bluetooth mode
7. LED indicator for Line-in mode
8,10. / Previous/Next song button- During music playback
in bluetooth mode, press to go to previous/next song.
9. Play/Pause button- During music playback in bluetooth mode,
press to play/pause.
11. LED indicator for Charging/Pairing

GD88BT Quick Start Guide
Getting Started
Carefully remove the speaker from packet.
Charging
When battery power is low, charge the speaker by connecting GD88BT to a
computer or USB power adapter via the supplied USB cable.
The red LED indicator on will light on, indicating that it is on charging
mode.
The red LED indicator on will turn off when fully charged.
Turning on/ off the speaker
To turn on the Portable Speaker, press and hold the Power button for
about 3 seconds until the LED indicator lights on
To turn off the portable speaker, press and hold the Power button for
about 3 seconds to turn off the speaker until the LED indicator turns
off.
Playing music
Please follow the below steps to play music.
1. Plug the connector to the music source,e.g. PCs/laptops, MP3 players or
radios.
2. Turn on the Portable Speaker, then the red LED indicator on will light
on.
3. Start playing the selected music or radio from the music source.
4. Press the +/- Volume button to increase or decrease the volume level.

GD88BT Quick Start Guide
Setting Bluetooth mode
1. Turn on the Portable Speaker and exit from Line-in mode to enter
bluetooth mode, then the red LED indicator on will turn off and the
blue LED indicator on will blink.
2. The bluetooth device of music source will search for GD88BT speaker,
then select the “GD88BT” and pair the GD88BT speaker with the Bluetooth
device.
Note: when the speaker is connected to bluetooth device, the blue LED
indicator on will always light on.
3. Start playing the selected music or radio from the music source.
4. Press the / button to go to next/previous song.
5. Press the button to play/pause the music playback.
6. Press the +/- Volume button to increase or decrease the volume level.
7. Press the Pairing button to exit from bluetooth mode.
Note: If there is no response on the speaker, press the Reset button at the
bottom of the speaker.
Table of contents
Popular Speakers manuals by other brands

Clark Synthesis
Clark Synthesis TACTILE SOUND AQ339 Aquasonic installation guide

Gembird
Gembird TD-SPK-BT-17-CM user manual

Wild Boar Audio
Wild Boar Audio WBA Whole Hog installation manual

Blackfire
Blackfire BBM9113 instructions

Blaupunkt
Blaupunkt BP1491 Instruction guide

bem wireless
bem wireless EXO-400 user guide