Galaxy DE 902682 Manual

TITLE DECLARATION OF CONFORMITY according to FCC Part 15
Name of third party responsible Northwest EMC
Address 22975 NW Evergreen Pkwy, Suite 400
Hillsboro, OR 97124
Phone number 503-844-4066
Compliance statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
Part 18 compliance This device complies with Part 18 of the FCC Rules.
Advisory statement
This product may cause interference to radio equipment and
should not be installed near maritime safety communications
equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz.
The interference potential
of the device or system
Maintenance of the system Unplug the unit, wait 30 seconds, and plug the unit back in.
Simple measures that can be taken
by the user to correct interference
Move the unit away from any radio device.

POSSIBLE CAUSES CORRECTIVE MAINTENANCE
LAMP LOOSE
IN SOCKETS
Make sure that the lamp is fully inserted into the sockets and that the
sockets are in the closed position.
INCORRECT
VOLTAGE
Make sure you are using the correct input voltage with ballast. If using
incorrect voltage, disconnect the ballast from the power source immediately.
DEFECTIVE
OR IMPROPER
WIRING
Examine wiring to ensure it agrees with wiring diagrams on ballast label.
Check connections to see that they are secure. If wiring a 240V ballast,
DO NOT use a neutral. The correct wiring is two hot wires and a ground.
POOR ELECTRICAL
CONNECTIONS
Check wiring and lamp contact with socket. Make sure the lamp cord is
firmly seated in output receptacle.
INCORRECT
LAMP
Verify that you are using a 1000W double ended lamp. Lamps manufactured
according to European or Asian specifications will not provide consistent
performance.
LAMP
DAMAGE
Investigate possibility of outer bulb damage.
Look for broken tubes or loose metal parts. Replace lamp.