Garage Tek GT1301 User manual

INSTALLATION INSTRUCTIONS
GT1301 – FOLDING TABLE W/ RESIN TABLE TOP
CARTON #1 CONTENTS CARTON # 2 CONTENTS
ITEM QUANTITY DESCRIPTION QUANTITY DESCRIPTION
A 1 TOP BRACKET - 48” WIDE 1 TABLE TOP – 2FT X 4 FT
B 1 BOTTOM BRACKET - 2 STIFFENERS
C 2 FOLDING ARM ASSEMBLIES 8 SCREWS – 1”
- 8 NUTS, WASHERS, YELLOW CAPS
TOOLS REQUIRED - PHILLIPS SCREW DRIVER / PLIERS
OPTIONAL FOR EASIER ASSEMBLY: ELECTRIC DRIVER, PHILLIPS DRIVER BIT,
3/32” DRILL BIT, SOCKET WRENCH SET.
PG 1 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11

FOLDING TABLE W/ RESIN TOP - ASSEMBLY INSTRUCTIONS
STEP #1: CHECK CONTENTS OF BOTH CARTONS
STEP #2: PLACE TOP BRACKET (A) THE DESIRED DISTANCE FROM THE FLOOR. MOUNT THE 2 FOLDING
ARM ASSEMBLIES (C) ON THE TOP BRACKET AND FASTEN WITH THE SUPPLIED NUTS,
WASHERS & YELLOW END CAPS AS SHOWN. HAND TIGHTEN NUTS ONLY
STEP #3 STEP #4
STEP #3: MOUNT BOTTOM BRACKET (B) AND FASTEN WITH THE SUPPLIED NUTS, WASHERS & YELLOW
CAPS AND WRENCH TIGHTEN THE TOP NUTS.
STEP #4: PLACE THE 2 STIFFENERS ON THE UNDER SIDE OF THE TABLE TOP AS SHOWN.
PG 2 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11

STEP #5 STEP #6
STEP #5: FASTEN THE STIFFENER ENDS W/ THE SUPPLIED SCREW AS SHOWN IN 4 PLACES. THE TOP OF
THE STIFFENERS ARE TO BE FLUSH WITH THE RIBS AT EACH END.
STEP #6: PLACE THE TABLE TOP BACK EDGE IN LINE WITH FOLDING BRACKET ASSEMBLY AS SHOWN.
(THIS IS IMPORTANT SO THE TABLE TOP CAN BE “LIFTED” TO DOWN INTO THE FOLDED POSITION. )
STEP #7 THIS COMPLETES THE GT1301 ASSEMBLY.
STEP #7: WITH THE SUPPLIED 1” SCREWS, FASTEN THROUGH THE REAR 2 HOLES IN EACH BRACKET
ASSEMBLY INTO THE STIFFENER PREVIOUSLY INSTALLED ON THE TABLE TOP IN STEP #5..
PG 3 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11

FOLDING TABLE OPERATION
DIAGRAM OF OPERATING STEPS
PG 4 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11