Garage Tek GT1305-1E User manual

INSTALLATION INSTRUCTIONS
GT1305-1E –WALL MOUNT TABLE BRACKETS
CARTON CONTENTS
ITEM QUANTITY DESCRIPTION
A 1 TOP BRACKET - 48”WIDE
B 1 BOTTOM BRACKET –37”WIDE
C 2 MAIN SUPPORT BRACKET
D 1 SHELF, 12 X 31
- 8 NUTS, WASHERS, YELLOW CAPS
- 4 SCREWS, 1”LG
IMPORTANT NOTE: THE GT1305-1E PRODUCT CONSISTS OF THE METAL BRACKET & SHELF SETUP ONLY.
A TABLE TOP IS NOT SUPPLIED WITH THE PURCHASE AND IS THE CUSTOMER’S RESPONSIBILITY TO
SUPPLY A TABLE TOP OF HIS / HER CHOICE. A TABLE TOP IS SHOWN IN THE ABOVE AND FOLLOWING
IMAGES AS A SUGGESTION OF WHAT CAN BE DONE AND CLARIFY THE ASSEMBLY STEPS. THE TOP USED
CAN BE 24”-30”DEEP AND 48”TO 72”WIDE.
TOOLS REQUIRED - PHILLIPS SCREW DRIVER / PLIERS
OPTIONAL FOR EASIER ASSEMBLY: ELECTRIC DRIVER, PHILLIPS DRIVER BIT,
SOCKET WRENCH SET.
PG 1 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11

WALL MOUNT TABLE BRACKETS –ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP #1: CHECK PARTS RECEIVED.
STEP #2: PLACE TOP BRACKET (A) THE DESIRED DISTANCE FROM THE FLOOR. MOUNT & FASTEN THE
2 MAIN SUPPORT BRACKETS (C) ON THE TOP BRACKET AS SHOWN. NOTE: THE SHELF
MOUNTING HOLES ARE TO BE ON THE INSIDE OF THE BRACKETS.
STEP 3 STEP 4
STEP #3: MOUNT BOTTOM BRACKET (B) AND FASTEN WITH THE SUPPLIED NUTS, WASHERS
& YELLOW CAPS
STEP #4: LOCATE THE SHELF IN-LINE WITH THE HOLES AND FASTEN IN PLACE WITH THE SUPPLIED SCREWS.
STEP 5 COMPLETE
STEP #5: WITH 1/2”TO 1”SELF DRILLING SCREWS FASTEN THROUGH ANY 2 HOLES IN
EACH BRACKET ASSEMBLY. (THESE ARE CUSTOMER SUPPLIED SCREWS)