Garden Oasis 534-4284-FS111-1 User manual

See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
OWNER’S
MANUAL
Panorama 9pc Dining
Set-Slate Table
Date of purchase: _____/ _____/ _____
Caution: Carefully Read Instructions and
Procedures for Safe Operation
Product Code: D71 M80259
KSN: 01331387-9
UPC code: 050874 290991
Made in / Hech en CHINA
Distributed by Sears, Roebuck and Co., Hoffman Estates, IL 60179
sears.com
For questions or comments about product:
Email: www.agio-usa.com or Call toll-free: 1-800-416-3511
Please refer to part numbers when reordering

5 2
Step 5: With the help of another person, carefully place the natural stone table top onto the table base.
Guide the bolts in natural stone table top (assembled in Step 2) into the holes of the “L” metal
brackets as shown in Fig. 4. After making any necessary adjustments to the alignment of the
bolts in the natural stone table top and the “L” metal brackets, add a nuts, spring washers and
Ø18x1.5 mm washer to the end of each bolts, as shown in Fig. 5, and tighten. Do not over
tighten.
Your table is now ready for use. If you have any questions, please call our Customer Service Center
at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or imporper
assembly is not covered under our warranty. Please read all instructions carefully before assembly.
I
f you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.

4
IMPORTANT!! PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE
KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
3
Step 1: Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts
packed in carton against the parts list. If you are missing any parts or are unsure as how to
proceed with the assembly, Please call our Customer Service Center at 1-800-416-3511.
Do not attempt assembly if any parts are missing or damaged.
Step 2:
Place the natural stone table top upside down on a flat, non-abrasive surface. Insert four
1/4”x35 mm headless bolts into the pre-drilled hole on the underside of the natural stone
tabletop as shown in Fig. 1 Do not over tighten.
Step 3: Attach a leg to the connector bracket. Add Ø6.5x1.0 mm washers and
spring washers to
1/4”x35 mm bolts and carefully guide the bolts through leg connector bracker and into the
pre-drilled holes in the table leg (each leg uses four bolts--two on each side) as shown in
Fig. 2. Do not over tighten. Repeat on remaining leg.
Step 4: Attach “L” metal bracket to top base using two 1/4”x18 mm bolts and spring washers and
Ø6.5x1.0mm washers as shown in Fig. 3. Guide bolts through holes in “L” metal bracket
and into pre-drilled holes in the top base. Do not over tighten. Repeat for remain “L” metal
brackets.