Step 5. Insert the six End Plugs into the square ends of the
Frames and use a hammer to gently tap them into place.
Step 6. Rest the Light Garden on a table and place the Poly
Tray on the table between the A Bars. You are now
finished assembling the frame.
Installing and Adjusting the Light Tubes
Step 1. Place the Light Fixture Hood upside down on a level
surface. This will reveal the Ballast Clips inside (Figure ).
Important: Remove the Light Tubes to prevent breakage
during assembly (Figure ). Reinstall them when the light
fixture assembly is complete.
Step 2. Push a Ballast into each set of Clips, making sure to
center the Ballasts in place (Figure ). Important: Each end
of the Ballast has an open pin (“female”) and closed pin
(“male”) socket. Place the Ballasts with one male and one
female socket at each end of the Light Fixture.
Step 3. Plug a power cord into the end of one Ballast.
Step 4. Connect the Light Tubes together by plugging in the
Link Cord. The Link Cord is specifically molded to fit
only one way on the end of each Ballast (Figure ,
next page). If is does not fit, make sure the Ballasts
are positioned with one male and one female socket
at each end of the Light fixture.
Step 5. Install the Light Tubes by sliding the pins on the
Light Tube into the Ballast sockets, then rotate the
Tube degrees until it “locks” into place (Figures
and a). Installing the Tubes correctly will ensure
they produce the optimum amount of light. Do not
force the Tubes into place. Turn the Light Fixture
upright. Remove the protective plastic film from the
black side of the Light Fixture Hood.
Fluorescent Bulb Care and Disposal
To ensure maximum light output, clean the fluorescent
tubes monthly with a soft dry cloth.
The light intensity of fluorescent bulbs diminishes over
time. When it’s time to replace your bulbs, please dispose of
them safely at your recycling center.
T- Fluorescent Bulbs contain Mercury and must be
disposed in accordance with Disposal Laws.
See www.lamprecycle.org or call --- for
disposal information.
assembly continues on next page
Figure 4
Ballast
Ballast
Clip
closed pin
male socket
open pin
female
socket
Figure 5
Figure 5a
Slide pins
into sockets
Light
Tube
Rotate 90 degrees
until Tube "locks"
into place.
A3
Spacer
Guide
Hole
Bolt
A1 Side
Frame
Ball
Chain
-2-
Figure 3
