Garmin GPS II Installation instructions

Dash Mount Instructions
Standard Parts:
u
Bracket 0)
Pivot Base (1)
Velcro (2)
3mm
Locking Knob (2)
1. Insert the GPS unit into the bracket:
A. Mate the two clips at the bottom of the
bracket with the notches
in the bottom
of the GPS unit. Snap the clips at the top
of the bracket into the notches in the
top of the unit by pressing
firmly.
B. (Optional) Use the 3mm locking knob to
secure the bracket to the back of the GPS
unit for added security in rough terrain.
(Fig. 1) (Note: Use only the knobs sup-
plied with the mount. Using incorrect
hardware may damage your mount.)
2. Remove the GPS unit from the bracket:
Unscrew the locking knob if necessary.
Press the top of the bracket outward and
flex it to release the clips from the unit.
Fig. 1

3. Attach the pivot base to adesired
De
surface using one of two methods:
A. Use the supplied velcro to secure the
?it
/
..-
11
pivot base, placing one part of the strip
on the desired surface and the corre- LI
sponding half in the pocket on the bot-
tom of the bracket (Fig. 2), or... Fig. 2
B.
...use two flat-head screws to secure the
pivot base to the desired surface. Use -
~
the pivot base as atemplate for locating II
the screw holes (Fig. 3).
/if
~
~
Fig. 3
4. Secure the unit and attached bracket
to the pivot base:
Match the pin holes at the bottom of the
bracket with the pins in the pivot base
and slide together. Attach the locking
knob through the side of the pivot base
and screw into the bracket (Fig. 4).
5. Adjust the angle of the unit:
loosen the locking knob that's screwed
through the side
of the base. Move the
unit (attached
to the bracket) to the
desired angle,
and tighten the screw
(Fig. 5)
I;:; I
Fig. 4
Fig. 5
© 1996 GARMIN Corporation; 1200 E. 151st Street, Olathe, KS 66062 USA
Part Number 190-00131-00 Rev. A