Gate Motors Q60AR User manual

Wireless Key Pad with Receiver –Wiring Guide for Q60AR / Q71A, Q71B
STEP 1 –Remove PCB Casing
Single screw holds the internal PCB holder to the
outer casing. Remove this screw and pull down the
bottom section
This will expose the terminals and the push buttons
for synchronising with wireless keypad.
STEP 2 –Wire to Control Board
With the two halves now
separated, terminals numbered 1 to
6 are seen.
Using CAT5 cable / alarm cable /
bell wire, insert cabling as follows:

STEP 3 –Program Keypad to Receiver
Before replacing PCB holder into it’s frame to be finally secured, we need to synchronise the keypad
with the receiver. This is a two stage process:
Stage 1 –On the keypad, Press and HOLD the “ON” button for 5 seconds, the red LED light will come
on. Then press “1111” followed by the “ON” button. The red LED will now start flashing.
Stage 2 –On the Receiver, press the second button down (as illustrated below)
Then press the “ON” button on the wireless Keypad. The Red LED light will change to green and you
will hear a confirmation tone. (beep twice). This process to completion has a 5 minute window.