GE UCG1600L How to use

UCG1600L
UCG1650L
UCG1680L
15 Inch Built-In Compactors
Technical Service Guide
June 2017
31-9268

– 2 –
Safety Information
IMPORTANT SAFETY NOTICE
The information in this service guide is intended for use by
individuals possessing adequate backgrounds of electrical,
electronic, and mechanical experience. Any attempt to repair a
major appliance may result in personal injury and property
damage. The manufacturer or seller cannot be responsible for the
interpretation of this information, nor can it assume any liability in
connection with its use.
WARNING
To avoid personal injury, disconnect power before servicing
this product. If electrical power is required for diagnosis or test
purposes, disconnect the power immediately after performing the
necessary checks.
RECONNECT ALL GROUNDING DEVICES
If grounding wires, screws, straps, clips, nuts, or washers used to
complete a path to ground are removed for service, they must be
returned to their original position and properly fastened.
GE Appliances
Technical Service Guide
Copyright © 2017
All rights reserved. This service guide may not be reproduced in whole or in part
in any form without written permission from GE Appliances.

– 3 –
Table of Contents
(Continued next page)
Safety Information..........................................................................................................................................................................2
Table of Contents............................................................................................................................................................................3
Safety Requirements......................................................................................................................................................................5
Nomenclature...................................................................................................................................................................................6
Introduction........................................................................................................................................................................................7
Technical Data..................................................................................................................................................................................8
Features....................................................................................................................................................................................8
Weights and Dimensions..................................................................................................................................................8
Power / Ratings......................................................................................................................................................................8
Helpful Publications.............................................................................................................................................................8
Installation Requirements.................................................................................................................................................9
Control Features.............................................................................................................................................................................10
Using the Built-In Compactor..........................................................................................................................................11
Care and Cleaning of the Built-In Compactor.........................................................................................................13
Changing the Foot Pedal...................................................................................................................................................13
Component Locator Views..........................................................................................................................................................14
15 in. Built-In Compactor..................................................................................................................................................14
Built-In Compactor Components.............................................................................................................................................16
Control Panel...........................................................................................................................................................................16
Switch Bracket.......................................................................................................................................................................16
ON/OFF Switch.......................................................................................................................................................................17
Top Limit Switch.....................................................................................................................................................................17
Directional Switch.................................................................................................................................................................17
Start Switch.............................................................................................................................................................................18
Tilt Switch..................................................................................................................................................................................18
Tilt Switch (Drawer)...............................................................................................................................................................19
Top Cover Panel.....................................................................................................................................................................19
Motor Assembly.....................................................................................................................................................................20
Ram Assembly........................................................................................................................................................................22
Power Screw Assembly......................................................................................................................................................24
Chain...........................................................................................................................................................................................25

– 4 –
Diagnostics and Service Information.....................................................................................................................................26
Schematic...........................................................................................................................................................................................28
Warranty.............................................................................................................................................................................................29
Index......................................................................................................................................................................................................30

– 5 –
Prior to disassembly of the compactor to access components, GE
Factory Service technicians are REQUIRED to follow the Lockout /
Tagout (LOTO) 6 Step Process:
Safety Requirements
GE Factory Service Employees are required to use safety glasses with side shields, safety gloves and
steel toe shoes for all repairs.
Steel Toed Work Boot Electrically Rated Glove and
Dyneema® Cut Resistant
Glove Keeper Dyneema®Cut Resistant
Glove
Plano Type Safety Glasses
Prescription Safety Glasses
Safety Glasses must be ANSI
Z87.1-2003 compliant
Brazing Glasses
Cut Resistant Sleeve(s)
Step 1
Plan and Prepare Step 4 Apply LOTO device and lock
Step 2
Shut down the appliance Step 5 Control (discharge) stored energy
Step 3
Isolate the appliance Step 6 “Try It” verify that the appliance is
locked out

– 6 –
Nomenclature
The nomenclature breaks down and explains what the letters and numbers mean in the model number.
Serial Number
7KH¿UVWWZRFKDUDFWHUVRIWKHVHULDOQXPEHULGHQWLI\WKHPRQWKDQG\HDURIPDQXIDFWXUH7KHOHWWHU
designating the year repeats every 12 years.
Example: LA123456S = June, 2013
A – JAN
D – FEB
F – MAR
G – APR
H – MAY
L – JUN
M – JUL
R – AUG
S – SEP
T – OCT
V – NOV
Z – DEC
2024 – Z
2023 – V
2022 – T
2021 – S
2020 – R
2019 – M
2018 – L
2017 – H
2016 – G
2015 – F
2014 – D
2013 – A
Model Designator
Designates features – the higher
the number, the more features.
U C G 1 6 0 0 L S S
Brand
U = Universal
Product Type
CG - Built-In Compactor
Exterior Color
BB = Black
SS = Stainless Steel
WW = White
II = Requires Custom
Cabinetry Panel
Model
Year Designator
The Model Serial plate is located
on the interior front panel
at the top, left corner of the
compactor drawer.
Model Serial Plate
Mini-Manual The mini manual is
located behind the control
panel.

– 7 –
Introduction
The 15 inch built-in compactor features a fully integrated design with hidden controls and a slide-out
compactor drawer. A removable ON/OFF knob prevents unwanted use. With 2,300 lbs. maximum compacting
force, the GE 15 in. built-In compactor reduces trash volume by 75%.
7KHFRPSDFWRULQVWDOOVÀXVKWRWKHVXUURXQGLQJFDELQHWU\$IRRWSHGDOSURYLGHVKDQGVIUHHRSHUDWLRQ
Pushing the foot pedal down opens the drawer and lifting the pedal up starts the 30-second maximum-
cycle-time compacting operation. Heavy-duty trash bags (Part #: WC60X5017) are supplied with the
compactor.
• 1/3 HP Motor
• Slide-Out Compactor Drawer
• Foot Pedal Opening and Start
• Large 1.4 Cubic Foot Capacity
• 5 Amps @ 120 VAC
• 150 lbs. Approximate Shipping Weight
• Model UCG1680LII accepts 3/4 in. custom panel, use the template publication # 31-31582.

– 8 –
• 49-55112: Quick Start Guide (available on
geappliances.com)
• 49-55111: Manual Use & Care Owner's Manual,
Use & Care (available on geappliances.com)
• 31-30851: Mini Manual (available on Tech
website ge-tag.custhelp.com, log in required)
• 31-31581: Instruction Install Installation
Instructions (available on geappliances.com)
• 31-31582: Mounting Template (Custom Door)
(available on geappliances.com)
Technical Data
Features
Weights and Dimensions
Power / Ratings
Capacity 1.4 Cu Ft
Compression Ratio (Avg.) 75%
Reduction
Control Location Hidden
Cycle Time < 25 seconds
Motor Horsepower 1/3 hp
Ram Force (lb.) 2300 lbs.
Lock/Start Switch w/Removable Key
Side Release Bin
Slide-Out Drawer
Color - WW, BB, SS and custom panel
Approximate Shipping Weight 144 lb
Cabinet Width 15 1/8 in
Net Weight (lbs.) 128 lb
Overall Depth (depending model) 23 in - 24 in
Overall Height 33 3/4 in
Cutout Dimensions (H x W x D
inches) 34-1/4 x 15- 1/8 x 24-3/4
Height w/Legs Extended (in.) 35
Height With Legs Retracted (In.) 33-3/4
Volts/Hertz/Amps 120 VAC; 60
Hz; 7.0 Amps
Helpful Publications

– 9 –
Clearance Requirements
WARNING: DO NOT OPERATE FREE-STANDING. This
compactor is designed as a built-in appliance only.
Weight on the compactor drawer could cause the
compactor to tip and result in injury.
The compactor must be securely installed in
DFDELQHWWKDWLV¿UPO\DWWDFKHGWRWKHKRPH
structure.
The compactor drawer should be able to be fully
opened to 23 inches (58.4 cm) for drawer removal.
Six inches (15.2 cm) is required on the right side of
the compactor for bag removal.
Custom Panel Size Requirements
Power Supply Requirements
The power supply cord and plug should be brought
to a separate 15 or 20 amp branch circuit single
grounded receptacle. The outlet box should be
located within reach of the 36 in. power cord.
This appliance must be supplied with 120 VAC, 60 Hz
and connected to an individual properly grounded
branch circuit, protected by a 15 or 20 ampere
circuit breaker or time delay fuse.
Installation Requirements
Models with a custom
door panel (UCG1680LII)
require a 3/4 in. thick
custom panel
29 5/16 inches high and
14 7/8 inches wide.
NOTE: Maximum panel
weight is 12 lbs.
Pub. No. 31-31582
includes complete panel
installation instructions
and a custom door panel
template.
33-3/4″
min.to
35″max
.
14-7/8″
23″
34″
to
35″
15-1/8″
min
24″
min
Locate the outlet18” min
from the floor, 3” min from
either side
24"
min 15-1/8"
min 34"
to
35"
Locate the outlet 18" min
IURPWKHÀRRUPLQIURP
either side
33-3/4"
min. to
35" max.
23" 14-7/8"
29-5/16″
14-7/8″
3/4″
Thick
Custom
Panel 29-5/16"
14-7/8"
3/4" Thick
Custom
Panel

– 10 –
Throughout this manual, features and appearance may vary by model.
Control Features
ADoor Panel EDrawer Safety Switch
BFoot Pedal Drawer Opener and
Compactor Activation FModel and Serial Number Label
CToe Kick GBag Retainer Buttons
DON/OFF Switch Moveable Side Door Latch