Minimum to
cabinets on
either side
of the range.
Minimum
clearance
to left wall
Minimum Minimum
clearance to
right wall
Maximum
depth for
cabinets above
countertops
Front edge of
the range side
panel forward
from cabinet
To cabinets below cooktop
and at the range back
To cabinets
below
cooktop and
at the range
back
18"
6"
30"
30" 13"
6"
36"
0"
0"
Product is shipped with 4-prong
plug. Recommended outlet is
a NEMA 14-50R receptacle.
7-1/2"
8"
9"
4"
30"
3"
3"
3"
2-1/4"
2"
NOTE: Make gas connections on
the left side and electrical conections
on the right side of the
cutout opening. Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
length is parallel to the floor.
Wall-Mounted
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
This area allows
flush installation
to rear wall.
GAS PIPE AND ELECTRICAL
OUTLET LOCATIONS
floor to counter
35" to 36 1/2"
3 1/4"
47 5/8"
29 3/8"
w/ handle
26 7/8"
w/o handle
30"
cooktop edge to edge
31 1/4"
SINGLE OVEN SLIDE-IN GAS RANGE
Minimum to
cabinets on
either side
of the range.
Minimum
clearance
to left wall
Minimum Minimum
clearance to
right wall
Maximum
depth for
cabinets above
countertops
Front edge of
the range side
panel forward
from cabinet
To cabinets below cooktop
and at the range back
To cabinets
below
cooktop and
at the range
back
18"
6"
30"
30" 13"
6"
36"
0"
0"
Product is shipped with 4-prong
plug. Recommended outlet is
a NEMA 14-50R receptacle.
7-1/2"
8"
9"
4"
30"
3"
3"
3"
2-1/4"
2"
NOTE: Make gas connections on
the left side and electrical conections
on the right side of the
cutout opening. Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
length is parallel to the floor.
Wall-Mounted
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
This area allows
flush installation
to rear wall.
GAS PIPE AND ELECTRICAL
OUTLET LOCATIONS
floor to counter
35" to 36 1/2"
3 1/4"
47 5/8"
29 3/8"
w/ handle
26 7/8"
w/o handle
30"
cooktop edge to edge
31 1/4"
SINGLE OVEN SLIDE-IN GAS RANGE
Minimum to
cabinets on
either side
of the range.
Minimum
clearance
to left wall
Minimum Minimum
clearance to
right wall
Maximum
depth for
cabinets above
countertops
Front edge of
the range side
panel forward
from cabinet
To cabinets below cooktop
and at the range back
To cabinets
below
cooktop and
at the range
back
18"
6"
30"
30" 13"
6"
36"
0"
0"
Product is shipped with 4-prong
plug. Recommended outlet is
a NEMA 14-50R receptacle.
7-1/2"
8"
9"
4"
30"
3"
3"
3"
2-1/4"
2"
NOTE: Make gas connections on
the left side and electrical conections
on the right side of the
cutout opening. Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
length is parallel to the floor.
Wall-Mounted
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
This area allows
flush installation
to rear wall.
GAS PIPE AND ELECTRICAL
OUTLET LOCATIONS
floor to counter
35" to 36 1/2"
3 1/4"
47 5/8"
29 3/8"
w/ handle
26 7/8"
w/o handle
30"
cooktop edge to edge
31 1/4"
SINGLE OVEN SLIDE-IN GAS RANGE
Specification Revised 8/13 221226
Dimensions and Installation Information (in inches)
P2S920SEF
GE Profile™ Series 30" Dual Fuel Slide-In Range with Warming Drawer
Listed by
Underwriters
Laboratories
For answers to your Monogram® or GE®
appliance questions, visit our website at
geappliances.com or call GE Answer Center®
service, 800.626.2000.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
*ADA qualified based
on Uniform Federal
Accessibility Standards
Note: Door handle protrudes 3" from door face. Cabinets and
drawers on adjacent 45° and 90° walls should be placed to
avoid interference with the handle.
Note: Cabinets installed adjacent to slide-in ranges must
have an adhesion spec of at least 194° temperature rating.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
