GE Profile PSH25SGSSV Manual

†Water hook-up fits in back air clearance when calculating
installation depth.
If installed against a wall, allow clearance of 13-15/16" on freezer
side to remove bin.
Clearance required to remove fresh food full-size pan without
disassembling is 18-5/8".
Allow additional space for any necessary leveling adjustments.
PSH25SGS
GE Profile CustomStyle™ ENERGY STAR® 24.6 Cu. Ft. Stainless Side-By-Side Refrigerator
"94 SxS Refer
A
Front View
Top View
G
D
C
F
BE
H
Listed by
Underwriters
Laboratories
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
Specification Revised 3/06 210285
R
R
Dimensions and Installation Information (in inches)
Overall
Dimensions
Height to top of hinge (in.) A 72-1/8
Height to top of case (in.) B 71-1/2
Case depth without door (in.) C†23-7/8
Case depth less door handle (in.) D†27-1/8
Case depth with door handle (in.) E†28-11/16
Depth with fresh food door open 90° (in.) F†46
Width (in.) G 35-3/4
Width with door open 90° inc. door handle (in.) H 37-5/16
Air
Clearances
Each side (in.) 1/8
Top (in.) 1
Back (in.) 1/2

For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
PSH25SGS
GE Profile CustomStyle™ ENERGY STAR® 24.6 Cu. Ft. Stainless Side-By-Side Refrigerator
Installation Tips to Maximize the Built-In Look
• All wall/floor molding should be removed prior to installation.
• Water recess on rear wall recommended to prevent water
line damage. 48" minimum length, 1/4" diameter water
line tubing recommended.
• When possible, recess both copper water line and electrical
outlet. (See local codes)
• Front and rear leveling legs are adjustable for the built-in look.
(See owner’s manual)
**The rough-in dimensions of 70-1/4"/72-1/4" are minimum and
measured from the finished floor to top of opening (or the
underside of the overhead cabinets). For Models with Trim Kit:
If frameless style cabinets are planned for above the refrigerator,
you may need to consider adding a maximum of 1/4" (70-1/2")
to height of opening for 23 cu. ft. models and 1/8" (72-3/8") for
25 cu. ft. models to allow for additional clearance between the
cabinet doors and the top of refrigerator trim when the cabinet
doors are in open position.
Rough-In Dimensions and Installation Information (in inches)
8' Ceiling
13" to 14"
Cabinet
12"
Soffit
36-1/8"
24-1/2"
*The rough-in dimensions of 70-1/4"/72-1/4" are minimum and measured from
the finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening for 23 cu. ft. models and 1/8" (72-3/8") for 25 cu. ft. models
to allow additional clearance between cabinet doors and top of refrigerator trim
when cabinet doors are in open position.
Collar Trim In. w/ceiling
70-1/4"*
23 cu. ft. models
72-1/4"*
25 cu. ft. models
Listed by
Underwriters
Laboratories
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Specification Revised 3/06 210285
R
R
25"
Counter
Top
ElectricalWater
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
Cabinet
25"
Counter
Top
Electrical Water
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
Cabinet
25"
Counter
Top
ElectricalWater
Trim
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
Cabinet
25"
Counter
Top
Electrical Water
Trim
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
Cabinet
FOR 21 CUBIC FOOT MODELS
FOR 24 CUBIC FOOT MODELS
Fig 2A eps

For answers to your Monogram,® GE Profile™or
GE®appliance questions, visit our website at
ge.com or call GE Answer Center®service,
800.626.2000.
PSH25SGS
GE Profile CustomStyle™ ENERGY STAR® 24.6 Cu. Ft. Stainless Side-By-Side Refrigerator
Listed by
Underwriters
Laboratories
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Specification Revised 3/06 210285
R
R
Collar Trim Installation
An enclosure is required to match up to the
trim, see Typical Installation. To obtain the
most integrated look, the cabinet or soffit
above the refrigerator should extend out
to the same depth as the side panels. The
refrigerator opening must have minimum
dimensions of 70-1/4" high x 36-1/8" wide
x 24-1/2" deep as shown at right. If there is
an overhead cabinet, allow 1" for cabinet
door clearance with the top trim piece so
the cabinet doors can be opened without
hitting the top trim. If 1/2" side panels are
used, then side trim and panel will be even.
If 3/4" side panels are used, then some of
the side panel will extend beyond the trim
and must be finished.
IMPORTANT: Before finalizing specifications
for your GE Profile CustomStyle Refrigerator,
please NOTE:
• A minimum of 36-1/8" is required for
refrigerator installation with collar
• Be sure to allow for 1/2" or 3/4" side
panels in addition to the 36-1/8"
minimum.
Typical Installation
Shaded areas represent front surfaces of side panels and
overhead cabinet or soffit that contacts trim.
Refer collar trim install
70-1/4"*
36-1/8"
24-1/2"*
1/2" minimum
*The rough-in dimension of 70-1/4" is minimum and is measured from the 
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to 
height of opening to allow additional clearance between cabinet doors and 
top of refrigerator trim when cabinet doors are in open position.
Collar Trim Installation Art
Rough-In Dimensions and Installation Information (in inches)
Magnetic
Tape
3/4" Cabinet
Side Panel
1/2" Cabinet
Side Panel
Side trim must be installed
flush with the gasket contact
surface on the case.
Refrigerator
Case
Side TrimDoor Gasket

Overhead
Cabinet
Cabinet
Door
Top Trim
Case
1"

PSH25SGS
GE Profile CustomStyle™ ENERGY STAR® 24.6 Cu. Ft. Stainless Side-By-Side Refrigerator
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Specification Revised 3/06 210285
Features and Benefits
• CustomStyle™Configuration - Offers a built-in look without the built-in expense
• Stainless Steel - Convey a look of utmost polish and sophistication
• ClimateKeeper2™System - Keeps food garden fresh longer, while protecting ice from odor
transfer, with its unique dual-evaporator system
• CustomCool™Technology With Full Extension Slides - Chills in minutes thaws in hours and
keeps foods fresher, longer
• Upfront, Electronic Touch Temperature Controls with Digital Temperature Display -
Precise and easy to use, taking the guesswork out of setting accurate temperatures
• Integrated Ice™System - Frees up valuable freezer space. It tilts down, providing easy access
to bulk ice
• Tall LightTouch! Dispenser with LED lighting- Delivers chilled water, cubed and crushed ice at the
slightest touch
• Slide ‘n Store™Full-Extension Freezer Baskets - Extends 12" to 16" beyond the cabinet, providing
easy laoding and unloading
• FrostGuard™Technology - Protects frozen items from freezer burn by monitoring door openings
and defrosting only when needed
• Integrated Shelf Support System - Provides strong, yet flexible support
• Adjustable Slide-Out, Spillproof Glass Shelves - Shelves slide out, spills stay put
• QuickIce™Option - Makes ice up to 50% faster than normal settings-ideal for entertaining
• TurboCool™Setting - “Revs up” the refrigerator, cooling it quickly after frequent door openings
• Model PSH25SGSSV - Stainless steel
PSI23SGR
PSI23PSR
WAT
ER
CRUSHED
CUBEDCLOCKSET
LIGHT
DOORALARMRESETWA
TERFILTER
HOLD3SEC.
LOCKCONTROL
HOLD3SEC.
Arctica