ToOperate
LAMP SWITCH ‘FM SVWK3-1
LampSwitch
FormodelsJV322 and JV332, switchhasOFF
and ON positions.Forother models,CENTER
positionOFF, LEFT positionNIGHT LIGHT,RIGHT
positionBRIGHT LIGHT.
FanSwitch
CENTER positionOFF, LEFTpositionSLOW
SPEED, RIGHT positionHIGH SPEED.
To Maintain
GreaseFilter
The efficiency of your hood depends on aclean
filter. Frequency of cleaning depends on the type
of cooking you do. BUT GREASE FILTER
SHOULD BE CLEANED AT LEAST ONCE
AMONTH. NEVER OPERATE THE HOOD
WITHOUT THE FILTER IN PLACE.
To remove: Pressoutward on spring clip, pull
down and snap out filter.
To clean: Soak and then agitate in ahot detergent
solution. Light brushing may be usedto remove
imbedded soil. Rinse, shake and remove moisture
before replacing.
Withcarefulhandling,the filterwill lastforyears,
If replacementbecomesnecessary,orderpart
numberWB2X2052fromyourdealer.
To replace: Put the filter rim in and againsttwo
clips, push outward on the third clip and press
filter upward into place.
Hood
Clean grease laden surfacesof the hood fre-
quently. Use warm detergent solution. About
1tablespoon of ammonia may be added to the
water. TAKE CARE TO NOT COME IN CONTACT
WITH FILTERS AND OTHER NON-ENAMELED
SURFACES. The hood shell can be washed, rinsed
and dried with asoft cloth.
CAUTION: Be certainwhen cleaninghood “
surfacesyoudo nottouchlampbulbwith
moisthandsorcloth.Awarmor hotlamp
bulb.maybreak iftouchedwith amoistsur-
face.ALWAYSlet lampcoolCOMPLETELY
beforecleaningaroundit.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY
AT THE HOUSEHOLD DISTRIBUTION PANEL
BY REMOVING THE FUSE OR SWITCHING
OFF THE CIRCUIT BREAKER.
2. Remove filter.
3. Wipe fan blade and motor with cloth, dampened
only in ammonia and warm water solution.
4. Replace filter.
5. Reconnect the hood power supply. e
Lamp ReplacementModels JV324J, JV624J,
JV334J andJV634J havea
lampcover.
The lampcoverneed notbe
removedfor lamp removalor
installation.
m
“-<CAUTION:‘Letlamp.cool coinpletelybefore
removing.-Awarmorhot bulb maybreak if e
touchedwith amoistcl?th or hand.
Remove lamp and replace with an ordinary screw-
base lamp bulb NOT MORE THAN 60 WATTS.
To remove lamp cover, if desired:
ePressthe sides with two fingers until the side
prongs are released.
●Lift lamp cover and slide towards you in one
motion.
To replace lamp covec
e
●
o
Insert prong located at end of cover into top
opening.
Gently push cover up and presssides to fit side
prongs into the side openings.
Release and the cover will lock in position.
