Geepas GK38021UK User manual

STAINLESS STEEL KETTLE
GK38021UK

IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions before using.
2. Before connecting the kettle to the power
supply, check that the voltage indicated on the
appliance (underside the kettle & base)
corresponds with the voltage in your home. If
this is not the case, contact your dealer and
stop using the kettle.
3. Do not let the cord hang over the edge of a table or
counter or touch a hot surface.
4. Do not place on or near a hot gas or electric
burner or in a heated oven.
5. Do not operate the appliance without anything in
it to avoid damaging the heat elements.
6. Ensure that the kettle is used on a firm and flat
surface out of reach of children, this will prevent
the kettle from overturning and avoid damage or
injury.
7. To protect against a fire, electric shock or
personal injury, do not immerse cord, electric
plugs or kettle in water or other liquids.
8. While water is boiling, or just after the water has
been boiled, avoid contacting with steam from
the spout.
9. Always take care to pour boiling water slowly and
carefully without tipping the kettle too fast.
10. Be careful of refilling when the kettle is hot.
11. This appliance is not intended for use by
persons (including children) with reduced
physical,sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of
the appliance by a person responsible for their
safety.
12. Children should be supervised to ensure that
they do not play with the appliance.
13. Do not touch the hot surface. Use the handle or
the button.
14. The attached base can not be used for other
than intended use
15. Extreme caution must be used when moving an
appliance containing hot water.
16. The appliance is not a toy. Do not let the
children play it.
17. The kettle is for household use only. Do not use
outdoors.
18. The use of accessories, which are not
recommended by the appliance manufacturer, may
result in fire, electric shock or personal injury.
19. Unplug the kettle from the outlet when not in
use and before cleaning. Allow the kettle to cool
before putting on or taking off parts, and before
cleaning the appliance.
20. To disconnect, turn any control to “off,” then
remove plug from wall outlet.
21. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard.
22. Do not use the appliance for other than
intended use.
23. The kettle can only use with the stand provided.
24. If the kettle is overfilled, boiling water may spill
out.

25. Always ensure the lid is closed and do not lift it
while the water is boiling. Scalding may occur if
the lid is removed during the brewing cycles.
26. Avoid spillage on the connector
27. This appliance is intended to be used in
household and similar applications such as:
– Staff kitchen areas in shops, offices and other
working environments;
– Farm houses;
– By clients in hotels, motels and other
residential type environments;
– Bed and breakfast type environments.
28.The heating element surface is subject to
residual heat after use.
29. Save these instructions.
KNOW YOUR ELECTRIC
KETTLE
Lid release button
(With indicator)
Switch
Water level gauge
Handle
Kettle lid
Power base
Body
Spout
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is
recommended that you should clean your kettle
before use by boiling the Max capacity of water
once and then discarding the water twice. Wipe the
surface with a damp cloth.
NOTE: The max capacity of kettle is 1.7L.
USING YOUR ELECTRIC KETTLE
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base
and open the lid by pressing down lid release
button, then fill the kettle with the desired amount of
water and close the lid. The water level must be
within the Min and the Max level. Too little water will
cause the kettle switching off before the water has
boiled.
NOTE: Do not fill the water over the maximum level,
as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before plugging
the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down
the switch and the indicator will light up, and then
the kettle starts to boil the water. The kettle will
switch off automatically once the water has boiled.
If necessary, it will take you 30 seconds to wait
before pressing the switch again to re-boil the water.
You may shut off the power by lifting switch up or
directly lift the kettle from the power base at any
moment to stop boiling process.
NOTE: Ensure that switch is free of
obstructions

and the lid is firmly closed, the kettle will not turn off
if the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour
the water.
NOTE: Operate carefully when pouring the water
from your kettle as boiling water may result in scald,
besides, don’t open the lid while the water in the
kettle is hot.
6. The kettle will not re-boil until the switch is
pressed again. The kettle may be stored on the
power base when not in use.
NOTE: Always disconnect the power supply when
not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate
without water, the function of boil-dry protection will
automatically switch off the power. If this occurs,
allow the kettle to cool prior to filling with cold water
before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power
outlet and cool it down completely before cleaning.
1. Never immerse the kettle, power cord or power
base in water, or allow moisture to contact with
these parts.
2. Wipe the appearance of body with a damp cloth
or cleaner, never use a poisonous cleaner.
3. Remember to clean the filter at intervals. For
easier cleaning, detach the filter by pressing down
the tab of filter inside the kettle and then replace
it
after cleaning.
CAUTION: Do not use chemical, steel, wooden or
abrasive cleaners to clean the outside of the kettle
to prevent the gloss loss.
4. When not use or storage, the power cord may be
wind under the bottom of kettle.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the
mineral deposits in tap water may form scale on the
bottom of kettle so as to cause the operation less
efficiency. You can use the commercially available
descaler and follow the instructions on the package
of descaler. Alternatively, you may follow below
instructions using the white vinegar.
1. Fill the kettle with 3 cups of white vinegar, then
adding water to the amount so as to cover the
bottom of kettle completely. Leave the solution in
the kettle overnight.
2. Then discard the mixture in the kettle, then filling
the kettle with clean water to the maximum position,
boiling and then discard the water. Repeat several
times until the odor of vinegar has been flushes
away. Any stains remaining inside the spout can be
removed by rubbing with a damp
cloth.

89

10 11

12 13