GENERAL MANUFACTURING, INC.
1100 S. MORGAN ST.
BLUFFTON, IN 46714
PHONE: (260) 824-3440
FAX: (260) 824-3448
One Year Warranty
This new light was thoroughly tested and inspected and found to be in
perfect working order before leaving our factory. If within one year from the
date of purchase, any part of this worklight proves to be defective in material
or workmanship, such defective part will be repaired or replaced (company
option) free of charge, at our factory. The company's liability in all events is
limited to the purchase price paid.
The warranty does not apply to the fluorescent lamp nor does it apply to
damage, alteration, misuse or abuse not attributed to General
anufacturing, Inc., its representatives, dealers or their employees. This
warranty does not apply if the product is mishandled or operated at a voltage
exceeding, that shown on the product.
General anufacturing, Inc. has made a diligent effort to illustrate and
describe the products in its literature accurately, however such illustrations
and descriptions are for the sole purpose of identification and do not express
or imply a warranty that the products will necessarily conform to the
illustrations or descriptions.
When returning product for warranty repair, please provide: a brief
description of your problem and your return address.
SAVE ALL INSTRUCTIONS
Care & Operation of your New
50W 120V PLL Industrial String Lite
Parts - 50W 120V PLL Industrial String Lite
CAUTION: Note Caution Labels on Lighthead
1. Inspect cord regularly for damage and replace if necessary for user safety.
2. Do not submerge fixture in liquids.
3. Do not use in areas requiring explosion-proof fixtures.
4. Disconnect light from power source before relamping.
5. Do not hang fixture by electrical cord. Use manufacturer’s hooks or mounting
brackets.
6. Take care not to bend or drop fixture - damage may result to lamp.
7. Power supply cord is UL listed and meets OSHA requirements for grounding of hand
held tools.
8. When used in wet locations, a GFCI must be provided.
OPERATION & MAINTENANCE
1. Plug the unit into a 120 VAC outlet. The power supply cord is UL listed and
meets OSHA standards.
2. Disconnect the power supply before servicing.
3. Keep the unit freefrom grease and dirt by using a damp cloth with mild detergent
or waterless hand cleaner.
4. Do not use solvents such as gasoline to clean unit or cord as it makes the parts
brittle.
RELAMPING INSTRUCTIONS
Note: for relamping instructions, refer to label located inside the outer tube of the
fixture. Note: When ordering replacement parts, please furnish light model
number located on label of light.
Note: We recommend you use ONLY original replacement parts.
