Generation Lighting McHenry Ol12800 User manual

1
Installation Instructions for
McHenry Outdoor Lantern (LED)
1.2
OL12800_OL12801_OL12802-LED
Ol12800, OL12801, OL12802-L1
Wall
Secure the mounting plate to the junction box.
For Model OL12802 Only: Screw the cap nut onto the fixture backplate.
Install the diffuser by sliding it into the fixture from the bottom and secure with thumb screws.
Install the outer glass panels by sliding them into the fixture from the top and secure them in place with the clips.
Place the cover onto the fixture and secure it using the cover screws.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white wire to the neutral power line wire with a wire nut.
Connect the black wire to the hot power line wire with a wire nut.
Neatly place the wires and wire nut connections into the junction box, mount the fixture base onto the mounting plate,
and secure it with the fixtures screws.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
1A
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
1
1
7
8
JUNCTION BOX
NEUTRAL WIRE
HOT WIRE
WHITE WIRE
BLACK WIRE
MOUNTING
PLATE
FIXTURE
SCREW
COVER
THUMB SCREW
CLIP
DIFFUSER
3
4
5
6
7
8
9
5
10
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
OUTER GLASS PANEL
COVER SCREW
FIXTURE
3
4
3
9
9
CAP NUT ( )Model OL12802 Only
10

SAVETHESE INSTRUCTIONS!
2
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2019 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.