English
4-1/2" Angle Grinder
Operator’s Manual GAG445SE
APPLICATION
GRINDING AND SANDING OPERATION
WARNING: Never force the tool. The weight of the tool applies adequate
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
ALWAYS replace the wheel if the tool is dropped while grinding.
NEVER bang or hit the grinding wheel or disc onto the work.
Avoid bouncing and snagging the wheel, especially when working on corners, sharp
edges, etc. This can case loss of control and kickback.
NEVER use the tool with wood carving blades or other saw blades. It is only designed
for grinding, sanding, or wire brushing.
WARNING: After operation, always switch off the tool and wait until the wheel
comes to a complete stop before putting the tool down.
OPERATION WITH WIRE BRUSHES
WARNING: In normal wire brushing operations, the material being removed
and brush bristles will fly off, going great distances with extreme force. The potential
for serious injury exists. To protect against this hazard, the operator and others in the
work area must wear protective clothing and safety goggles. Wearing a full face mask
over safety glasses with side shields is highly suggested.
WARNING: Always be sure that the tool is switched off and unplugged before
adjusting, adding accessories, or checking a function on the tool.
