Genica GN-675VA User manual

Power Supply
GN-675VA
GN
675VA
UNINTERRUPTIBLE
GN-675VA
Back Panel
Func ions
USER GUIDE
GN-675VA
System
Power switch to “I”
Position & LED and
Alarm are OFF
Power switch to “I”
position & LED is
blinkin YELLOW
Red LED Li ht on
Probable Cause
Power cord disconnected
City power failure
AC fuse blown
Control PCM error
GN-675VA input volta e
over HI transfer volta e or
under low transfer volta e
Control PCB error
Battery under or GN-675VA
as been shutdown
STATUS LINE MODEM
To Modem
From
Telephone
Line
Main
Switch
Outlet
Socket
Outlet
Socket
Outlet
Socket
AC Input
Socket
Fuse &
Spare
Fuse
Internet Protection
LAN
Interface
Troubleshoo ing Guide
Recommended Solution
Connect power cord
Turn the power switch to “O”
position. When the city power has
resumed, turn the power to “I.”
Remove the load from the GN-
675VA. Check the fuse near outlet,
replace the fuse if it is blown.
Call Dealer for Service
Make sure the volta e of city
power is correct.
Call Dealer for Service
Char e battery, shut down,
condition will release automatically.
Overview:
The GN-675VA protects your sensitive electronic equipment from power disturbances. A power
outa e can occur when you least expect it – threatenin the loss of critical data. The Genica
GN-675VA Uninterruptible Power Supply works as a battery back up to protect your
equipment and data in the event of a power loss. In addition, the ARV (automatic volta e
re ulator) and built-in line conditioner provides stable volta e when power fluctuates.
Also includes modem protection! By routin your modem cable throu h the GN-675 your
modem will also be protected from dama e by occurrences such as a li htnin strike.

Meaning of LED and ALARM
STATUS LED COLOR ALARM SOUNDS STATUS CONDITION
Green X City power normal and battery full
Green Blinkin X City power normal and battery char in
Yellow Blinkin 1 Time 2 Sec City power loss
Yellow Blinkin 1 Time 1 Sec City power loss & battery low
Red City power loss and battery low –
Or the GN-675VA has been shut down.
Yellow 25% Battery char ed 25%
Yellow 50% Battery char ed 50%
Yellow 75% Battery char ed 75%
Yellow 100% Battery char ed 100%
Impor ance No ices:
•Read instructions carefully before operatin the GN-675VA UPS.
•All operation instructions should be followed.
•The GN-675VA should be power by a rounded power source.
DO NOT OPERATE THE GN-675VA WITHOUT a rounded power source.
•Replace fuse with the same type and ratin only.
Warning:
•Don’t open the cover, there are no user serviceable parts inside.
•Don’t insert any object into ventilation holes or other openin s.
•The GN-675VA is for computer use only.
Sys em Func ion:
•Automatic volta e re ulator. Built-in line conditioner provides stable
volta e when power fluctuates.
•Monitorin software allows the user to view status of the GN-675VA
•Modem (modem line) protection.
•Overload and short current protection.
•Automatically detect circuit and battery char e / dischar e protection.
www.genica.com
Elec rical Specifica ion
Inverter Capacity: 675VA
AC Input 110V +/- 20% 60Hz
Inverter Output (rms) 100VAC or 120VAC
Inverter Re ulation +/- 3%
Cosine 0.6
Inverter Frequency 50 or 60Hz + 2%
Transfer Time -< 3ms
Full Load Back-up Time 3 minutes
Battery Specification 7AH / 12V x 1
Opera ion Ins ruc ions (FOR US / 110V use ONLY)
•Make sure that you are plu in the unit into 110v wall outlet
(city power) and that the power switch is in “O” position.
•Plu AC (power) cord into the outlet and plu the power cord
of the computer and peripherals into the female outlet of the
GN-675VA.
•Turn the power switch on back of the GN-675VA in the “I” position
and wait for about 3 seconds (soft start). Now the UPS is in AC
operation mode and DC inverter output is in “stand by” mode.
•When AC input power is interrupted (AC power failure) the led will
start blinkin yellow, and an alarm will sound. The GN-675VA will
switch to battery operation mode automatically.
CAUTION: After initial start-up, keep power on continuously to the GN-
67 VA for at least 12 hours to ensure batteries are fully charged.