Genius SP-HF1100X User manual

Service Guide SP-HF1100X
Version 1.0 Page 1 of 14
SERVICE GUIDE
KYE SYSTEMS CORP

Service Guide SP-HF1100X
Version 1.0 Page 2 of 14
SP-HF1100X
Version:1.0
Revision History
Version Date Change
1.0 2008/03/06

Service Guide SP-HF1100X
Version 1.0 Page 3 of 14
Table of Contents
RevisionHistory 2
TableofContents 3
GettingStarted 4
Conventions Used in this Guide 4
SafetyPrecautions 4
Chapter 1. How to Handle Defective Returns 5
1.1Overview 5
1.2Problems 6
1.2.1 L/R channels no sound 7
1.2.2No power 8
Chapter 2. Specifications R / L 9
Chapter 3. Block Diagram 10
Chapter 4. Exploded View R / L 11
Chapter 5. Part List 12
Chapter 6. Schematic Diagram 13
Chapter 7. Important Notes 14
7.1 Packing Requirement for Sending the PCB Assembly by post 14
7.2 Short of Spare Parts while Repairing a Speaker system 14

Service Guide SP-HF1100X
Version 1.0 Page 4 of 14
Getting Started
Conventions Used in this Guide
Pay Special Attention: Instructions that are important to remember and may
prevent mistakes.
Caution: Information that, if not followed, may result in damage to the
product.
Safety Precautions
The following precautions should be observed in handling the speaker
described in this guide:
Place the speakers on a flat, level and stable surface.
Do not place the speakers in environments subject to mist, smoke,
vibration, excessive dust, salty or greasy air, or other corrosive gases and
fumes.
Do not drop or jolt the speakers.
Do not allow anything to drop into the subwoofer case through its
ventilator, as it could result in fatal electric shock or fire.
Place the unit far enough from other equipments for good heat dissipation.
Disconnect the AC power cord from the AC outlet before performing any
maintenance on the speakers.
Do not perform any maintenance with wet hand.
Prevent foreign substances, such as water, other liquids or chemical, from
entering the speakers while performing maintenance procedures on the
speakers.

Service Guide SP-HF1100X
Version 1.0 Page 5 of 14
Chapter 1. How to Handle Defective Returns
1.1 Overview
Receiving Defective speaker form customers
Analyzing possible
malfunction causes
Deciding & proceeding the
rectification methods
Replace necessary
defective
p
arts
Return the speakers with proper
re
p
acka
g
in
g
to customers
Verifying problems
proceeding
necessar
y
tests
Proceeding tests to
verify if the speaker is
functionin
g
normall
y
Function OK
Function NG
Function OKFunction NG

Service Guide SP-HF1100X
Version 1.0 Page 6 of 14
1.2 Problems
Item Problem Description
1.2.1 L/R channels no sound
1.2.2 NO power

Service Guide SP-HF1100X
Version 1.0 Page 7 of 14
* Attention
Please follow the numbered sequence marked within parenthesis given in individual
Flow chat, in that this is the best-recommended sequence to rectify the problems.
1.2.1 L/R channels no sound
Problem
Analyze and
Identify the Causes
Solutions
L/R channels no sound
Broken or short circuit
Check solder points on
PCB
Defective
U1,U2,VR1,VR2,VR3,
C1,C3,C21,C22,L1,L2,
PHONE1,CON3
Speaker cable dis-connect or
speaker damaged
Re-connected speaker cable
or replace defective speakers
Check and replace
defective IC or
components

Service Guide SP-HF1100X
Version 1.0 Page 8 of 14
1.2.3 No power
Problem
Analyze and
Identify the Causes
Solutions
No power
Broken or short circuit
Check solder points on
PCB
Defective
D1,D2,D3,D4, SW1,
Transformer
Speaker cable dis-connect or
speaker damaged
Re-connected speaker cable
or replace defective speakers
Check and replace
defective components

Service Guide SP-HF1100X
Version 1.0 Page 9 of 14
Chapter 2. Specifications
R/L (AT 1KHZ):
NO Description Unit Specifications
1 Out Power at THD 10% W >14
2 Sensitivity mV 800 ± 50
3 Freq Response (Ref:-3dB) Hz 20~20K
4 Separation dB > 30
5 S/N ratio dB > 78
6 Hum & Noise Vol:max mV <5

Service Guide SP-HF1100X
Version 1.0 Page 10 of 14
Chapter 3. Block Diagram

Service Guide SP-HF1100X
Version 1.0 Page 11 of 14
Chapter 4. Exploded View
Host ( R )
L

Service Guide SP-HF1100X
Version 1.0 Page 12 of 14
Chapter 5. Part List
NO DESCRIPTION Qty UNIT Part No
1 SP-HF1100X/BODY/R/230V-EU 1 PC F-000-063-0000
2 SP-HF1100X/BODY/L 1 PC F-000-063-0000
3 SPEAKER UNIT 4” 4 OHM 15-20W 2 PC S-000-000-0042
4 SPEAKER UNIT(High sound), 1” 4 OHM 10W 2 PC S-000-000-0043
5 RUBBER, Ø16*3/BLACK 8 PC 5-127-210-0020
6 MANUAL, SP-HF1100X 1 PC 5-035-055-0037
7 CUSHION(tip cover), SP-HF1100X 1 PC 6-008-000-0073
8 CUSHION(bottom cover), SP-HF1100X 1 PC 6-008-000-0074
9 PCBA SP-HF1100X 1 PC X-000-002-0154
10 IC TDA2030A (SJ) 2 PC Q-000-000-0014
11 PUSH SW 1 PC 3-166-000-0005
12 ROTARY SWITCH, B50K 1 PC 1-224-000-0056
13 ROTARY SWITCH, B50K 2 PC 1-224-000-0057
14 CARTON, SP-HF1100X 1 PC 6-017-078-0026
15 Gift box, SP-HF1100X 1 PC 6-012-076-0013
16 TRANSFORMER, 230V/12V*2/2A 1 PC 1-296-500-0137
17 SPEAKER CABLE, 1 to 0 RCA,1.3M 1 PC C-001-000-0006
18 AUDIO CABLE, 1 to 0 ST, 1.7M 1 PC C-000-000-0001
19 AUDIO CABLE, 1ST to 1 ST, 30CM 1 PC C-000-002-0000
20 POWER CORD, BLACK,EU,1.5M 1 PC 3-372-011-0038
21 CARTON LABEL, SP-HF1100X 1 PC 5-030-402-0018
22 S/N LABEL, SP-HF1100X 2 PC 5-030-401-0020
23 PE BAG, 480*350*0.04mm,SP-HF1100X 2 PC 6-002-000-0092
24 PE BAG, 200*100*0.04mm, POWER CORD 1 PC 6-102-000-0012

Service Guide SP-HF1100X
Version 1.0 Page 13 of 14
Chapter 6. Schematic Diagram

Service Guide SP-HF1100X
Version 1.0 Page 14 of 14
Chapter 7. Important Notes
7.1 Packing Requirement for Sending the PCB Assembly by Post
PCB assembly is a kind of sophisticated electronic circuit board. Well
packing will be required when sending them by post.
* Some sophisticated IC components are mounted on the PCB assembly,
hence it is necessary to pack each PCB assembly with a separate static
protecting bag, in order to avoid static electricity.
* Reliable external packing is also very important when sending PCB
assembly by post, in that it would avoid unnecessarily lost or damage.
7.2 Short of Spare Parts while Repairing a Speaker System
If you are short of spare parts when you have some speaker systems waiting
to be repaired, it would be recommended to take the necessary parts form
one speaker system, so that you may have the as many speaker systems.