Functions
Top Button
This is the button on the top of the unit, next to the LAN and Power In port.
One click –Turn on AT2 WiFi Router
One click –Turn off WiFi Router
Fast Double click –Turn off AT2 PowerBank (Not PoE)
Long click button –Turn on/off LED Light
24V / 48V Button
The 24v button is Yellow in color and the 48v button is Red. Be sure your device supports 48v and/or 24v
before plugging them in. The BatteryPoE does not have a method to detect what voltage should be applied,
therefore, it will apply the voltage you select. Look on the screen for the current voltage output.
If you set wrong voltage, there is a protection that turns off the PoE, but it is better not to abuse it.
One Click –Enable POE out with selected voltage and Enable WIFI
One Click –Disable POE out and disable WIFI
One Click at boot button –Show Test
Reset Button
The reset button is to either preform a firmware update or to factory Reset the unit. This is typically one
of the major troubleshooting steps that
Pressed during startup –firmware update
Pressed for 30 seconds when router is on–factory reset.
Yellow Battery LED Indicator
This indicator tells you when the unit is charging, and when it is completed charging. It also will tell you
when a low battery condition is enabled.
While charging = Blinking LED
End of Charge = LED ON
In discharging = LED ON
Low Battery = Blinking LED
