Gigabyte G152-Z12 User manual

Giga Computing GIGABYTEChannel@GIGABYTEServer GIGABYTEofficial
1
1
2
How To Install a Server into a Tank
G152
Installing Server
Installation
1 Attach the two carabiners to server handles.
2 Put the server into the tank vertically.
 Strongly recommended to use gloves when handling the coolant.
 Before handling coolant, handlers must read the material safety data sheet (MSDS) for their safety.
 The thermal pad contains Indium foil, so it is strongly recommended to use gloves
when replacing the thermal pad.
DANGER!
CAUTION!
 Make sure the crane can handle at least 60 KG before installing the server into a tank.
 Only licensed professionals are authorized to access the restricted access location.
 The power supply fan is disabled by default, so the server must be immersed in the fluid before powering on.
 Consult with immersion cooling tank vendor to ensure compatibility and read their tank manual thoroughly.
 Do not install a GPU into the system without consulting GIGABYTE first, doing so may cause
compatibility issues.

Giga Computing GIGABYTEChannel@GIGABYTEServer GIGABYTEofficial
Installing Optional Handles
2
2
3
1
1
NOTE! The optional handles are only for Asperitas tank.
1 Attach the handles to server.
2 Secure the handles with screws.
3 Install server into the tank.

Giga Computing GIGABYTEChannel@GIGABYTEServer GIGABYTEofficial
Learn more about GIGABYTE server, visit www.gigabyte.com/Enterprise
* All specifications are subject to change without notice. Please visit our website for the latest information.
* All other brands, logos and names are property of their respective owners.
© 2023 Giga Computing Technology Co., Ltd. All rights reserved.
Engineered by
How To Install a Thermal Pad to CPU
Installing Thermal Pad
Installation
1 Place the thermal pad on the top of CPU.
 Strongly recommended to use gloves and mask when handling the thermal pad.
 The thermal pad contains Indium foil, so it is strongly recommended to use gloves
when replacing the thermal pad.
DANGER!
2 Install the CPU heatsink.
When installing the heatsink to CPU, use a Torx T20 screwdriver to tighten 4 captive nuts in sequence as 1-4.
The screw tightening torque: 10 ± 0.5 kgf-cm.
4
3
1
2