Glacier bay HD67522X-5201 Assembly instructions

THANK YOU
INSTALLATION AND CARE GUIDE
TUB FILLER FAUCET
We appreciate the trust and condence you have placed in Glacier Bay through the purchase of this tub ller
faucet. We strive to continually create quality products designed to enhance your home. Visit us online to see
our full line of products available for your home improvement needs. Thank you for choosing Glacier Bay!
8/2017 REV.01HOMEDEPOT.COM
Questions, problems, missing parts?
Before returning to the store, call Glacier Bay Customer Service
8 a.m. - 7 p.m., EST, Monday - Friday
9 a.m. - 6 p.m., EST, Saturday
1-855-HD-GLACIER (1-855-434-5224)
HOMEDEPOT.COM
Model#
HD67522X-5201
Internet#
304685562
SKU#
1003222975

Phillips
screwdriver
2
Table of Contents
Important Information..............................2
Warranty ...................................................2
Pre-Installation.........................................2
Planning Installation ..............................2
Package Contents..................................3
Installation................................................4
Care and Cleaning ....................................8
Troubleshooting........................................8
Service Parts ........................................... 9
Important Information
□ Observe all local plumbing and building codes.
□ Cover the sink drain to avoid losing any parts.
□ Review the care and cleaning section included in this guide.
Pre-Installation
PLANNING INSTALLATION
Before beginning the installation of this product, ensure all parts are present. Compare parts with the Package
Contents list. If any part is missing or damaged, do not attempt to install the product. Contact Customer Service
for replacement parts.
TOOLS AND HARDWARE REQUIRED
Adjustable
wrench
Safety
goggles
Tools and Hardware Required ...............2
Operation...................................................7
6mm
diameter
Electric
drill
Pencil
Warranty
LIMITED LIFETIME WARRANTY
Glacier Bay products are manufactured with superior quality standards and workmanship and are backed by our
limited lifetime warranty. Glacier Bay products are warranted to the original consumer purchaser to be free of
defects in materials or workmanship. We will replace FREE OF CHARGE any product or parts that proves defective.
Simply, return the product / part to any of The Home Depot retail locations or call 1-855-HD-GLACIER (1-855-434-
5224) to receive the replacement item. Proof of purchase (original sales receipt) from the original consumer
purchaser must be made available for all Glacier Bay warranty claims.
This warranty excludes incidental/inconsequential damages and failures due to misuse, abuse or normal wear and
tear. This warranty excludes all industrial, commercial and business usage, whose purchasers are hereby extended
a ve year limited warranty from the date of purchase, with all other terms of this warranty applying except the
duration of warranty.
Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations may not apply to you. This warranty gives you specic legal rights and you may also have other
rights that vary from state to state and province to province. Please see a store or contact 1-855-HD-GLACIER for
more details.
Contact the Customer Service Team at 1-855-434-5224 or visit www.HomeDepot.com.

3
Pre-Installation (continued)
PACKAGE CONTENTS
HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Part Description Quantity
A 1
B Set screw 1
C Mixer 1
Spout
D 1
E Escutcheon 1
Standpipe
Part Description Quantity
F 3
G Anchor 3
H Showerhead 1
Screw
I 1Shower hose
J 12.5mm Hex wrench
A
C
B
K
D
E
F
G
H
I
J
K Set screw 1

4
Installation
1 Preparing for installation
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□Shut off the water supply. Remove the old
faucet. Clean the surface in preparation for
the new faucet.
□Loosen the set screw (B) pre-assembled to the
spout (A) with the Hex wrench (Hex: 2.5mm, J),
rotate the spout (A) about 90° to face the spout
(A) towards the front, then tighten the set screw
(B) with the Hex wrench (Hex: 2.5mm, J).
2 Installing the escutcheon
□Place the escutcheon (E) over the standpipe (D)
and push it to the base.
D
E
B
A
A
J

5 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
3 Attaching the mixer to the
standpipe
□Attach the mixer (C) to the standpipe (D), making
sure the prongs (1) on the standpipe (D) insert
into the hole (2) of the mixer (C).
□Install the set screw (K) and tighten into the
standpipe (D) with Hex wrench (Hex: 2.5mm, J).
4 Drilling the holes & Making the
waterline connections
NOTE: Do not reverse the hot and cold supply.
Hot inlet
supply line
Front
Cold inlet
supply line
KJ
C
D
1
2
1
□Mark the locations for the screws with a pencil
(1). With an electric drill (2), drill three 1/4 in.
diameter holes for the screws in the oor.
Place the anchors (G) into the holes.
□Connect the exible supply lines (3) to the water
supplies (4).
6mm dia.
Floor
2
Floor
33
4
4
1
G

6
Adjusting the spout and mixer
□Loosen the set screw (K) with the Hex wrench
(Hex: 2.5mm, J) at the back of mixer (C), adjust
the spout (A) and mixer (C) toward the front and
in the middle, then tighten the set screw (K) with
the Hex wrench (Hex: 2.5mm, J).
6
Installation (continued)
5 Securing the faucet assembly
□Ensure the standpipe (D) sits ush against the
nished oor surface. Then secure the standpipe
(D) using screws (F).
□Push the escutcheon (E) over the standpipe (D)
base so that it sits ush against the nished
oor surface.
K
C
A
J
D
E
F

7 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
7
Connecting the shower hose
□Connect one end of the shower hose (I) to the
mixer (C) and the other end to the showerhead (H).
□Ensure the washer (1) is placed into each end
for seal.
1
I
H
C
1
Operation
1Flushing and checking for leaks
□Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. Press the pin (1) to the bottom position,
and ush water lines for one minute. This
ushes away any debris that could cause
damage to internal parts. Check for leaks.
□After ushing, turn the handle all the way
off to shut off the water. The pin should
now be in its normal position. Re-tighten
any connections if necessary, but do not
overtighten. 1

8
Care and Cleaning
□To clean, wipe down with a damp cloth and dry with a towel.
□Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
Problem Possible Cause Solution
There are leaks from the
handle.
The bonnet nut has come loose and/or the
washer is dirty or damaged.
□Tighten the bonnet nut.
□Clean or replace the washer.
The water will not shut off
completely.
The cartridge is dirty or broken. □Remove the handle to check
the cartridge.
□Clean or replace.
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.

9
Service Parts
*Specify Finish
Faucet ID tags can
be found on the
hot water inlet
Many replacement cartridges, aerators, and drain
assemblies can be purchased at your local The
Home Depot store or online at HOMEDEPOT.COM
Part Description Part Number
1 RP38348*
2 Shower hose RP38236
3 O-ring RP60107
4 Set screw RP50002
5 Cartridge & Screw RP20097
6 Bonnet nut RP70015
Showerhead
Part Description Part Number
7 RP80008*
8 Handle assembly RP13545*
9 Screw RP50037
10 Anchor RP50036
Cap
2
1
3
4
4
5
6
7
8
10
9

Questions, problems, missing parts?
Before returning to the store, call Glacier Bay Customer Service
8 a.m. - 7 p.m., EST, Monday - Friday
9 a.m. - 6 p.m., EST, Saturday
1-855-HD-GLACIER (1-855-434-5224)
HOMEDEPOT.COM
Retain this manual for future use.