GlassOuse GS02 User manual
GS02 - PUFF SWITCH USER MANUAL
WARNINGS
• While removing your Puff Switch from your GlassOuse
or other devices, pay attention not to damage the wire
joining points both on the 3.5mm jack connector and the
Bite Switch module parts.
•
To change the battery, remove the soft silicone cover of
Puff Switch module and the battery inside, and then
place the new one. Please pay attention to “positive” (+)
remark on the battery during replacement.
• Keep Puff Switch away from magnets.
7th Floor, Huarong Building, Qiaolian East, Bulong Road,
Longgang District, 518129, Shenzhen, Guangdong, China
P. 0086-755-8920-5835 F. 0086-755-8980-5835-812
PUFF SWITCH
Offering short circuit low signals, even though Puff Switch is
genuinely designed for GlassOuse V1.2, you can connect it
to any kind of adapted device offering a mono 3.5mm jack
connector plug in for external switch controls. Other than
regular sip and puff systems, Puff Switch uses an electronic
system, which allows you to do clicking actions via simple
puffs.
Puff Switch works with 125mAh 3V CEBA CR1632 coin size
battery. The battery life can go up to two months and it is
easy to change. The built-in microphone has a blow trigger
converting the frequencies derived from puffing action into
signals automatically to do the clicks. Puff Switch’s smart
battery system turns the device off in one hour if it is not
used. The switch also can be turned off manually via pressing
the small button placed on the module.
USER MANUAL
7th Floor, Huarong Building, Qiaolian East, Bulong Road,
Longgang District, 518129, Shenzhen, Guangdong, China
P. 0086-755-8920-5835 F. 0086-755-8980-5835-812
SWITCH CONNECTION
1. Plug Puff Switch to Glassouse V1.2 or any 3.5mm jack adapted device via 3.5mm connector.
2. Adjust the position of Puff Switch wire until you feel comfortable enough to do puffing action.
3. Press the power button on your switch to activate Puff Switch. The LED light will flash. Press the power button
again to turn off your Puff Switch. The LED light will flash for three seconds.
LED SIGNALS
The LED light on Puff Switch tells you the sensitivity via blinking speeds. Press and hold power button for 3 seconds.
1. High Sensitivity - The LED light blinks nine times in fast speed.
2. Medium Sensitivity - The LED light blinks six times in medium speed.
3. Low Sensitivity - The LED light blinks three times in low speed.
GS02 - PUFF SWITCH
Lenght: 170mm x Width: 24.5mm x Thickness: 11mm
Weight: 11g
Cable Length: 110mm
Battery Type: CR1632 3V coin size battery
DEVICE
3.5MM JACK
MICROPHONE
SILICONE COVER
Table of contents
Other GlassOuse Switch manuals
