
4
fCordless Wet/Dry Vacuum
OPERATION INSTRUCTIONS
1. To turn vacuum on or o, use the on/o switch located
at the front of the vacuum cover. When turning vacuum
on, make sure it is properly plugged in rst while it is
still o. Turn switch o before unplugging after nishing
vacuuming, or when changing accesories.
2. To connect hose to vacuum, insert end of hose into inlet
and rotate clockwise until locked. To remove, rotate
counterclockwise and then pull.
3. To use the blower, turn the on/o switch o. Insert end
of hose into air outlet, located in the left of the vacuum
cover, then turn clockwise to tighten. Turn the switch on.
WEAR EYE PROTECTION AND A DUST MASK WHEN USING
THE BLOWER.
4. To connect wet/dry nozzle to hose, insert end of hose
into brush outlet and rotate clockwise until tight. To
remove, rotate counterclockwise and then pull.
5. Clean the vacuum tank after every use. To access the
vacuum tank, remove the vacuum cover by opening the
two side clamps and pulling the cover up and out of the
tank. If contents of the tank are wet, clean and dry the
tank after discarding contents.
6. Clean the HEPA lter after every use. To access the lter,
remove the vacuum cover. Turn the lter locking knobs
counterclockwise and remove the lter. Clean the lter
under cold, running water. Do not use detergents or
soaps to clean the lter.
WARNING
DO NOT use vacuum to suck
or blow burning or ammable
material or otherwise hazardous
chemicals
1
2
4
5
6
6
3