GNCI MRM X1100 User manual

+ =
“CLI CK”
1.
2.
3.
4.
Slide the MRM X1100 Gateway into the mounting bracket. Ensure it clicks into place.
Slide the USB modem into the MRM X1100 Gateway's USB port.
.
a. Slide the end-stop piece firmly against the USB modem.
b. Use the supplied foam pads to adjust the height of the USB modem so that
it sits level with the router. Use multiple foam pads if required.
This kit contains foam pads of the following thicknesses:
2x 1.5 mm, 2x 3 mm, 1x 6 mm
a. Turn the mounting bracket bottom-side up.
b. Insert and tighten the supplied screw into the end-stop piece.
This will ensure the USB modem stays in place.
GNCI MRM X1100 Gateway and Modem Mounting Bracket
Installation Instructions

IP-Addr:
Hostname:
Contact:
Asset-ID:
5.
6.
7.
9.
a. Insert the 8” cable tie through the holes in the mounting bracket
and tie down the USB modem.
b. Cut off any excess lengh. Do not over tighten!
The mounting bracket kit includes:
2 drywall screws and anchors
2 wood screws
4 rubber feet
Use the appropriate mounting hardware to secure the
mounting bracket to the wall, cabinet or other surface.
If your installation requires an external antenna,
use the supplied 4" cable ties to fasten the
antenna cable to any of the 7 loops on the
mounting bracket.
Insert the supplied Micro-USB power cable
into the MRM X1100 Gateway's DC power jack
and feed the cable through the strain relief
on the mounting bracket as shown.
Attach the optional stickers.
8.
rev 1.01
Global Net Commerce, Inc. (GNCI)
711 West 17th Street, Unit G-9
Costa Mesa, CA 92627
Phone: [phone]
Fax: [phone]
Web: www.gnciwireless.com
Email: [e-mail]