Go Jo LTX Operating and maintenance manual

! Warning (In according to FCC part 15.19):
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
! Caution (Pertaining to FCC part 15.21):
Modifications to this equipment not expressly approved by GOJO Industries, Inc. could
void the user's authority to operate the equipment.
This unit is certified to FCC Part 15 Part C for intentional unlicensed radiators. FCC ID O76-T4SG0910A
LTXTM Acvity Monitoring System
transmier module installaon procedure

1.
Press the LTX door latches inward
to release the door. 2.
Pull the top of the door forward.
3.
Use a athead screwdriver to li the slot
cover away from the cabinet. 4.
Remove and discard the
slot cover.
5.
Remove the LTX trans-
mier module from the
packaging and straighten
the antenna wire.
6.
Align the transmier module base into the ng in the door,
and feed the antenna wire up through the retainierslots.
Antenna wire retainer slots

7.
With the antenna wire in place, swing the top of the module
down and snap into place to secure the module.
10.
Remove the baery tab to apply power to the LTX
dispenser.
8.
Check to ensure that the baery tab is
present. If the baery tab is not present,
place a baery tab into the slot before
proceeding to the next step.
9.
Insert the module cable into the jack on the
front of the pump house, and press in rmly
to secure the plug.
11.
Load the dispenser with an appropriate product rell if needed. Close the dispenser door and watch for the
green light to start ashing aer a few seconds. If the light ashes red, or does not ash at all, reopen the
door and check for problems.
Status light
Baery tab