Go Power GP-BMK-50 User manual

1 x Face plate
1 x Mounting plate
4 x Screws
1 x Battery
Monitor Connector
2 x Pos. supply
cable
1 x Battery monitor 1 x Battery
coupling
1 x UTP cable
Go Power! Quick Start Guide: GP-BMK-50
©2018 Go Power! INSTALL_GP-BMK-50_RevC
©2018 Go Power! | 201-710 Redbrick Street, Victoria, BC Canada V8T 5J3 | [e-mail]
PLANNING
INCLUDES:
GP-BMK-50
BATTERY MONITOR
Quick Start Guide
Plan where the battery monitor will be located in the RV keeping your
50’ of cord in mind.
2
1
INSTALLATION
1. Trace the base of the battery monitor on the wall where it will go (See Figure 2-A)
2. Cut out the circle you have traced, (See figure 2-B)
3. Remove any sharp edges from the hole.
4.
5.
In Method 1, place the coupling through the wire and connect the wire tothe
battery monitor. (See figure 3-A)
6. In Method 2, click the mounting plate onto the battery monitor. (See figure 4-A)
Screw the coupling onto the back of the monitor. (See figure 3-B)
7. Place the monitor into the hole that has been cut and trace the four small
holes for the screws. (See figure 4-B)
8. Then pull the monitor out and connect the cable before reinserting. (See
figure 4-C)
9. Place the connected monitor back into the hole and secure with the four
screws before snapping the faceplate on for the final step. (See figure 4-D)
FIGURE 2-A
FIGURE 2-B

FIGURE 3-A
INSTALLATION METHOD 1
INSTALLATION METHOD 2
-C
FIGURE 3-B
FIGURE 4-A FIGURE 4-B
FIGURE 4-C FIGURE 4-D
©2018 Go Power! | 201-710 Redbrick Street, Victoria, BC Canada V8T 5J3 | [e-mail]
Go Power! Quick Start Guide: GP-BMK-50
©2018 Go Power! INSTALL_GP-BMK-50_RevC

©2018 Go Power! | 201-710 Redbrick Street, Victoria, BC Canada V8T 5J3 | [e-mail]
BATTERY SHUNT CONFIGURATION
to battery to load
+B2
+B1
UTP
Battery Monitor Connector
Go Power! Quick Start Guide: GP-BMK-50
©2018 Go Power! INSTALL_GP-BMK-50_RevC
WARNING - ELECTRIC SHOCK Connect the negative pole of the battery LAST!
GP-BMK-50 CONFIGURED FOR STARTER/MAIN/AUXILARY
BATTERY MONITORING WIRING DIAGRAM
Go Power! Direct
GP-BMK-50
Bluetooth
Dongle

WIRING DIAGRAMS
K
Go Power! Quick Start Guide: GP-BMK-50
©2018 Go Power! INSTALL_GP-BMK-50_RevC
PLEASE NOTE:
©2018 Go Power! | 201-710 Redbrick Street, Victoria, BC Canada V8T 5J3 | [e-mail]
Connect the negative pole of the battery LAST!
Go Power! Direct
GP-BMK-50
Bluetooth
Dongle
gpelectric.com/support/battery-monitor-support
at
for more information:
gpelectric.com/support/battery-monitor-support