Go Et-15000 sp Manual

The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is

not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.

Graphics One, GO (Graphics One), are trademarks of Graphics One. All other trademarks are properties of their respective companies.

+1-818-260-9591 • sales@graphicsone.com • www.graphicsone.com

SUPPORT

GOTEK TB-PR 005-V2

PAGE 1

GO ET-15000 SP Film Setup

ScreenMate™ Film Installation on ET-15000

This technical bulletin describes the procedure on how to print film with the GO ET-15000 printer.

1. With the pinter, you will receive a box of film and the ScreenMate™ Film Guide. The ScreenMate™ Film Guide is

needed so the media sensor will detect the film for imag- ing.

Prepare one sheet of ScreenMate™ Film and the

ScreenMate™ Film Guide. The ScreenMate™ Film Guide is

the white media

which is included with each box of film.

2. Prepare one sheet of Screenmate™ Film and the

ScreenMate™ Film Guide. The ScreenMate™ Film must

have the printing side facing up.

3. Insert one of the corners of the ScreenMate™ Film

on the Film Guide.

The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is

not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.

Graphics One, GO (Graphics One), are trademarks of Graphics One. All other trademarks are properties of their respective companies.

+1-818-260-9591 • sales@graphicsone.com • www.graphicsone.com

SUPPORT

GOTEK TB-PR 005-V2

PAGE 2

4. ScreenMate™ Film needs to be aligned with the

edge when it is inserted into the Film Guide corner.

5. The Screenmate™ Film Guide has a double-sided

piece of tape at the bottom, that starts at the center,

and goes to the right edge.

5. Please remove the protective tape cover and press

the film firmly along the tape to adhere the film to the

guide.

6. Load the ScreenMate™ together with the Film Guide

with the corners first and the printing side facing up.

7. Send your file to the GO ET-15000 SP printer using

your preferred application (FilmMaker or Design

Software).

8. Remove the printed ScreenMate™ Film from the

GO ET-15000 SP exit tray.

The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is