GOLDMUND METIS 10 – Acoustic Processor - 8
5 FIRST INSTALLATION & CONNECTIONS (Ctd.)
5.2 SPEAKERS LOCATION (Ctd.)
In stereo, the ideal location of the speaker in the room has to be found by experiment.
However, avoid placing the speakers in the corner of the room and try to set them away
from any adjacent wall by 60cm (2 feet) minimum. The proper listening position is located
by 1 to 1.5 times the distance between the speakers at equal distance from each other. If
the room size permits, try separating the speakers by minimum 3 meters (10’) to provide a
large stereo image.
In multi-channel system, it is recommended to put your Metis speakers as close as
possible to the recommended positions shown in the picture above. This configuration will
guarantee the best sound quality of your Metis system.
A standard configuration is available from the Goldmund Universal Configurator with
corresponding speakers. Please contact your authorized Goldmund retailer to assist you to
set up your unit.
Note: The distances between listening point and all speakers systems have to be identical.
If not, delays corresponding to distance differences will have to be entered in the Universal
Configurator to create a custom configuration.
5.3 SOURCE AND SPEAKERS CONNECTION
Before connecting any source or speaker to the Metis 10, make sure that all your devices
(Metis 10, audio sources, amplifiers and speakers) are turned off.
Connect the analog sources to the back panel analog inputs and the digital sources to the
digital inputs of the Metis 10.
The inputs are numbered on the back panel and correspond to the description below:
•1 to 3 : Analog RCA Input
•4 to 7 : Digital RCA SPDIF Input
•8 & 9 : Digital Optical Toslink Input
•10 : USB Input
