Good-Lite 700009 User manual

www.good-lite.com | 1.800.362.3860 | 1.888.362.2576 fax 1
IMPORTANT:
For situations calling for cabinet to swing open to the right, mount
the wall bracket with the swing hinge in the up position. To swing
open to the left, mount the wall bracket with the swing hinge down.
To lock bracket into the open postion, slide locking sleeve towards
middle of locking bar.
Mount the wall bracket to the wall using all four mounting holes.
Mount cabinet to wall bracket (see drawing). Position key hole slots
on back of cabinet onto wall bracket posts. Slide down into place.
To remove cabinet from wall bracket, reverse process.
Part Number: 700009
Mounting Instructions For Wall Bracket
Wall
Bracket
Wall
Bracket
Post
Mounting Holes
Key
Holes

www.good-lite.com | 1.800.362.3860 | 1.888.362.2576 fax 2
Part Number: 700009
Mounting Instructions For Wall Bracket
www.good-lite.com GOOD-LITE PH: 800-362-3860
FX: 888-362-2576 GL
700009
Illuminated Cabinet Wall Bracket Mounting Template
7.125"/18.0 cm
12"/30.48 cm
5"/12.7 cm
10"/24.4 cm
Not Actual Size

8 3/4" ON CENTER
USE THIS TEMPLATE FOR CORRECT PLACEMENT OF
MOUNTING SCREWS. INSTALL PROPER ANCHORS INTO WALL.
ADD SCREWS TO ANCHORS LEAVING APPROXIMATELY 1/16"
SPACING BETWEEN ANCHOR FACE AND SCREW HEAD.
CAREFULLY REMOVE BULB AND SET ASIDE. POSITION
KEY HOLE SLOTS ON BACK OF CABINET OVER MOUNTING
SCREWS AND SLIDE DOWN INTO PLACE. USING SIGHT
HOLE IN REFLECTOR, TIGHTEN SCREWS. REPLACE BULB.
www.good-lite.com | 1.800.362.3860 | 1.888.362.2576 fax 3