GOODWOOD AUDIO AC Interfacer User manual
INTERFACER
MANUAL
THE
AC
Electric and Acoustic through the same pedal board? You bet your
breathtaking hiney! The AC Interfacer combines loop switching and
auto-routing outputs giving you the freedom to use either acoustic
or electric guitar through selected groups of effects to either an
amp or DI; all with the press of one foot switch.
How to connect the AC Interfacer.
1. Loop B return
2. Tuner send
(below Loop B return)
3. Loop B send
4. Loop A return
(below Loop B send)
5. Loop A send
6. RGB LED – red = electric
/ blue = acoustic
7. Acoustic out
8. Electric out
9. Soft touch switch –
press to mute, hold
to switch between
AC & ELEC
10. Buffered input
11. VDC centre negative
only – mA
1
2
4
3
5
8
7
6
10
11
9
GUITAR
AMP
DI
ELECTRIC ONLY
EFFECTS
(fuzz &
overdrive etc.)
ELECTRIC &
ACOUSTIC
EFFECTS
(delay &
reverb etc.)
A RETURN
BELOW
B SEND
Master mute
To mute the outputs press the foot switch. The LED will light up to
show the mute is active.
Modes
To change mode hold down the foot switch for 3 seconds. The LED
will change colour to show which mode you’re changing to. You do
NOT have to be muted to change modes. When un-muted the LED
will flash to show which mode you’re switching to.
Red / Electric Mode
In this mode, both loops are active and the ELEC output is active.
The AC output is muted.
Blue / Acoustic Mode
In this mode Loop A is bypassed and the AC output is active. The
ELEC output is muted.
Loop A
This is where we recommend you have all the effects you want on
electric only. Typically overdrive, distortion, fuzz, boost, octave etc.
Loop B
This is where you have the rest of your effects that you want on both
electric and acoustic
If you want to use a compressor or any other pedal on both
acoustic and electric but you need it to be before loop A, plug your
guitar directly into that pedal. Then from that pedal go to the input
of the AC Interfacer.
@goodwoodaudio info@goodwoodaudio.com
Specs
Power: .mm barrel, centre negative, vDC power only!
Minimum mA
Dimensions (incl. all jacks and switches):
mm wide x mm deep x mm high
Weight: grams
Table of contents
