GOOVER PWR-G12V-030-66-U-D-J User manual

GOOVER
V1.2022.10
USER GUIDE
UNIVERSAL DIMMABLE LED DRIVER
< 1 > < 2 > < 3 >
Constant voltage output
Auto reset breakers, from short circuit,
overloading,& over temperature
Variable Input Voltage, 100-277VAC
Load 10-100%
Compatible with Triac, MLV,ELV,0-10V,
&PWM Dimmers
Dry & Wet location
Flicker-free dimming
5 year Warranty
Cooling by free air convection
Full protection metal case
FEATURES GENERAL WIRING DIAGRAM
PWR-G12V-030-66-U-D-J PWR-G12 V-0 60 -6 6- U- D- J PWR-G12V-300-66-U-D-JPWR-G12V-100-66-U-D-J PWR-G12 V-1 50 -6 6- U- D- J
TECHNICAL INFORMATION
LED Fixture
LED Fixture
G12 030 66-U-D-J
SERIESPOWEROUTPUT
PWR
MODEL/SKU
12 - 12 VDC 30W
60W
100W
150W
300W
MODEL/SKU
READ BEFORE INSTALLATION RISK OF SHOCK
If direct wiring to a 120 volt circuit with an ac dimmer turn off power at circuit
breaker before installing.
Always connect (+) to positive and (-) to negative. Make sure positive never
touches negative while powered.
Allow ventilation,do not install in an airtight compartment.Cooler surrounding
air temperatures extend driver life.
Operate only within temperature range of 4°F (-20°C) to 104°F(40°C).
Wiring must be in accordance with national & local electrical codes -low-voItage
Class 2 circuit.
Mount the driver flat to the surface to provide heat transfer for better cooling.
It is normal for driver to feel warm to the touch,especially when under a full
wattage load.
For wire runs inside walls, use certified CL2 or better cabling and appropriate
mounting hardware.
Never connect 2 LED drivers to a single run of LED strips.
Total wattage of LED fixtures connected to driver must not exceed wattage
rating of this unit.
If you don't know the wattage rating of your lighting,
ask the manufacturer of your lighting.

Have any question, please contact us !
[email protected]
5 - year warranty
< 5 >< 4 > < 6 >
Before installing, check the label and ensure the power
supply has the proper input voltage, output voltage, and
wattage for the job. Check the wire markings to ensure
they match the wiring diagram below. Refer to table
above for the maximum loads!
Power supply can be mounted vertically or horizontally.
With aminimum of 2" clearance around power supply
to provide properair circulation.
Remove the two Phillips screws from the top of the driver
housingand pull the cover off to expose the driver wires.
Insert the 120-277 VAC power into the driver housing from
the electrical panel . Folowed by bringing the 12V DC low
voltage wires from the LEDs into the driver housing .
In addition bring the controler wire if applicable .
Refer to diagram on page 2 to make all the proper wiring
connections .
WIRING DIAGRAW
Insert the wire nut connections in the driver housing and
close housing cover . Secure by tightening the two screws .
12V DC