Gorke Electronic Sp. z o.o.
SPECIFICATION AND USER’s MANUAL: 1-channel ANT-KO1/1 set strona: 3
Important! You can enter the programming mode ONLY when the relay is closed (diode K1 is off). In order to
close the relay, press the remote control button or temporarily disconnect the supply voltage.
1. REGISTERING A NEW REMOTE CONTROL
a) press the LEARNING button for more than 0,5 but less than 4 seconds – the K2 diode will light
b) press the remote control button – the diode K2 will fade
c) press the button once more – the diode K2 will light for 3 seconds, then it will start to pulse and will fade
d) the process of registering a new remote control is finished
If the registering fails, the diode K2 will blink once and then fade. In this case, you need to start the process
from the beginning. If the receiver's memory is full (14 remote controls have already been programmed),
programming next remote control will delete the one which had been programmed as the first. If the number of
users is larger than 14, you need to use receiver with extended memory – the S version (113 senders) or
configure the WLC 201 receiving module with an adequate number of LC receivers (two for 226 users, 3 for 339
users, etc.).
2. SETTING THE RECEIVER'S OPERATNG MODE
To set the receiver's operating mode, you need to have a remote control which has previously been entered into
the receiver's memory (point 1.). Manufacturing settings – the bistable mode.
The monostable mode (timer) – after sending the transmission from the remote control, the receiver's relay will
switch on for the pre-programmed time
Press the LEARNING button (the diode K2 will light) and keep it pressed until the K2 diode starts to pulse – then
release the button. After releasing the button, the K2 diode will emit continuous light for about 4 seconds and
then, slowly pulse. Each blink corresponds to one second.
For example, in order to set timer on 20 seconds, you need to count 20 blinks of the K2 diode and press the
remote control button, thus confirming the length of time. The maximal time available to set is 260s (4 min 20
s). If no button is pressed during the diode pulsing (time countdown), after counting to 260s, the K2 diode will
emit the continuous light for 1 minute. If during this time (the continuous lighting) the control button is pressed
(confirming), the receiver will set time on the maximum, that is, about 260s. If during this time the button is
NOT pressed, the receiver will quit the programming mode and will save the previous setting.
The bistable mode (flip-flop) – after receiving the transmission from the remote control, the relay flips on the
other state.
Press the LEARNING button (the K2 diode will light) and keep it pressed until the K2 diode starts to pulse – then
release the LEARNING button. After releasing the LEARNING button the K2 diode will emit the continuous light
for about 2s and during this period press the control button.
3. DELETING THE REMOTE CONTROLS FROM THE MEMORY
Keep the LEARNING button pressed.
Phase one: the LED K2 will light for about 4s.
Phase two: LED K2 will start to pulse and then it will fade, which means that the deletion is finished. Release the
LEARNING button.
1. one must remember that deleting concerns the whole capacity of the memory. If you want to remove
only one or several remote controls, you must re-enter the ones which are supposed to be saved.
2. If there are many users and you want to avoid the toilsome process of programming the controls
individually, you can use one of the identifying receivers (their parameters allow for deleting the
controls individually)
3. deleting the senders does not change the operating mode of the receiver
4. disconnecting the supply voltage does not cause losing the information about programmed controls or
the operating mode of the receiver.
