ATTENTION
Do not disassemble the device. Do not touch before unplugging the power supply if the device is
damaged, the power supply cables are not isolated or the isolation is damaged.
All wireless data transferring devices produce interference that may affect other devices which are
placed nearby.
The device may be connected only by ualified individuals.
The device must be firmly fastened in the predefined location.
The device is susceptible to water and humidity.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the e uipment. This e uipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This e uipment generates, uses and can radiate radio fre uency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
e uipment does cause harmful interference to radio or television reception, which can be determined
by turning the e uipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the e uipment and receiver.
-- Connect the e uipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This chapter contains information on how to operate “G79/G77” safely.
By following these re uirements and recommendations you will avoid dangerous situations. You must
read these instructions carefully and follow the strictly before operating the device!
The device uses a 8V-32V DC power supply. The nominal voltage is 12V DC. It is advised to transport
the device in an impact-proof package.
Before usage, the device should be placed so that its LED indicators are visible, which show what status
of operation the device is in.
When connecting the connection cables to the vehicle, the appropriate jumpers of the power supply of
the vehicle should be disconnected.
Before dismounting the device from the vehicle, the connection must be disconnected.
Copyright © 2014 Gosafe.
All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this
document in any form without the prior written permission of Gosafe is prohibited.
Other products and company names mentioned herein may be trademarks or trade names of their
respective owners.
