SP5600User Manual
ATTENTION!
Do not disassemble the device. Do not touch before unplugging the power supply if the device is
damaged, the power supply cables are not isolated or the isolation is damaged.
All wireless data transferring devices produce interference that may affect other devices which are
placed nearby.
The device may be connected only by qualified individuals.
The device must be firmly fastened in the predefined location.
The device is susceptible to water and humidity.
INSTRUCTIONS OF SAFETY
This chapter contains information on how to operate “SP5600”safely.
BY following these requirements and recommendations you will avoid dangerous situations. You must
read these instructions carefully and follow the strictly before operating the device!
The device uses a 8V-32V DC power supply. The nominal voltage is 12V DC. It is advised to transport
the device in an impact-proof package.
Before usage, the device should be placed so that its LED indicators are visible, which show what
status of operation the device is in.
When connecting the connection cables to the vehicle, the appropriate jumpers of the power supply of
the vehicle should be disconnected.
Before dismounting the device from the vehicle, the connection must be disconnected.
LEGAL NOTICE
Copyright © 2013
All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in
this document in any form without the prior written permission.
1-Wire is a registered trademark of Dallas Semiconductor.
Other products and company names mentioned herein may be trademarks or trade names of their
respective owners.
