GPX C226 User manual

FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS AND PRECAUTIONS
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• Mains plug is used as disconnect device and it should remain readily operable during intended use. In
order to disconnect the apparatus from the mains completely, the mains plug should be disconnected
form the mains socket outlet completely.
• Caution marking is located at the rear or bottom of the apparatus.
• WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain, moisture,
dripping, or splashing.
• CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or
sensitive nish. As with any rubber compound made with oils, the feet could cause marks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
• WARNING: Shock hazard - Do Not Open.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
• Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
• WARNING: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD. If you think batteries
might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• Do not mix old and new batteries.
• Completely replace all old batteries with new ones.
• Batteries should be recycled or disposed of as per state and local guidelines.
• WARNING: This product may contain chemicals known to the State of California to cause birth
defects, or other reproductive harm (California Prop 65). Wash hands after handling.
• This product meets and complies with all Federal regulations.
Orientation
Clock Radio with Dual Alarm
User’s Guide for Model C226 v1572-01
Clock/Mem
In Off mode, press
and hold to begin
setting the time.
In radio mode, press
to cycle through
preset stations.
Power/Source
Press to turn the unit on.
Press and hold to
turn off the radio.
Press repeatedly to
select AM or FM.
Snooze
Press to snooze the alarm after it sounds.
Sleep
Press repeatedly to set the
sleep timer.
Alarm 1: Buzzer/
Radio Indicator
Lights when the
alarm 1 is on and set
to buzzer or radio.
Volume −/AL1
Press to decrease volume.
Press and hold to set
Alarm 1 in power OFF.
Volume +/AL2
Press to increase volume.
Press and hold to set
Alarm 2 in power OFF.
PM Indicator
Lights when the
time is in the PM.
Alarm 2: Buzzer/
Radio Indicator
Lights when the
alarm 2 is on and set
to buzzer or radio.
Sleep Indicator
Lights when the
Sleep Timer is ON.
LED Display
Tuning/Hr/Min
Press to tune the radio.
Press to adjust the hours
and minutes when setting
the clock or alarm.
Features
• .6” red LED display with digital clock
• Dual alarm
• Wake to alarm or radio
• Sleep timer
• Snooze
• Digital AM/FM radio (PLL
with built-in antennas
• Radio station presets (10 FM/10 AM)
• Built-In speaker
• Digital volume control
• AC power: built-in AC power adapter
• Battery backup: requires 2 AAA batteries
for clock and last user settings

To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:
www.iLiveElectronics.com
Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección
de apoyo en: www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des questions fréquemment
posées, consultez la rubrique d’assistance sur: www.iLiveElectronics.com
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com
Customer Service: 1-888-999-4215 | Email Support: [email protected] | Email Parts: par[email protected]
Copyright © 2016 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective
owners. Specications are subject to change without notice.
International Support
Protect for Today
Sustain for Tomorrow
Made
Green
Setting the Alarm
1. If in radio mode, press and hold the Power/Source/AL OFF button to turn
the unit o.
2. Press and hold the AL1 or AL2 button until the display begins to blink.
3. Press the Hour button to set the hour. The PM indicator will light when the
hour is set in the PM.
4. Press the Min button to set the minutes.
5. Press the AL1 or AL2 buttons to select Radio, Buzzer, or Alarm OFF.
6. Once the set alarm time is reached, the alarm will sound.
7. To set the other alarm, follow the above steps and choose the alarm not
currently set.
An AM/FM antenna is built into the clock radio. To improve radio reception, adjust
the position of the clock radio.
Tuning the AM or FM Radio
1. Press the Power/Source/Al O button to turn the clock radio on.
2. Press the Power/Source/Al O button again to switch between the AM and
FM radio mode.
3. Press the Tun+/− buttons to adjust the radio to the desired frequency.
4. Press and hold the Tun+/− buttons to search for the next available
frequency.
5. Press the Vol+/− buttons to adjust the volume.
6. Press and hold the Power/Source/Al O to turn the radio o.
Clock & Sleep Timer
Alarm
Radio
Setting the Clock
1. If in radio mode, press and hold the Power/Source/Al O button to
turn the unit o.
2. Press and hold the Clock/Mem button until the display begins to blink,
then release the button.
3. Press the Hour button to adjust the hour. The PM indicator will light when the
hour is set in the PM.
4. Press the Min button to adjust the minute.
5. Press the Clock/Mem button to nish setting the time.
Setting the Sleep Timer
1. Power ON the unit and press the Sleep button repeatedly to set the sleep
timer ( 90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF ).
2. Once the set sleep time has expired the clock radio will automatically
power o.
Disabling the Alarm
1. Press the AL1 or AL2 buttons repeatedly until the indicator is no longer lit.
Snooze and Alarm Reset
After the alarm sounds:
Press the Snooze button to delay the alarm for an additional 9 minutes.
OR
Press the Power/Source/Al O button to turn the alarm o
until the set alarm time is reached again.
Saving Radio Presets
1. Tune to the desired station.
2. Press and hold the Clock/Mem button. When the display begins ashing,
press the Tuning/Hr/Min buttons to select a preset (P01-P10).
3. Press the Clock/Mem button to save the station to the preset.
4. After saving a preset, you can press the Clock/Mem to cycle through you
saved preset stations.
Power & Battery
Requires 2 AAA batteries (not included).
The battery backup is intended for short power outages only. The clock
radio’s primary functions cannot run o of the battery backup alone.
To power the unit, plug the power cord on the back of the unit into a
standard AC power outlet.