GPX C336 User manual
FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS AND PRECAUTIONS
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• Mains plug is used as disconnect device and it should remain readily operable during intended use. In
order to disconnect the apparatus from the mains completely, the mains plug should be disconnected
form the mains socket outlet completely.
• Caution marking is located at the rear or bottom of the apparatus.
• WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain, moisture,
dripping, or splashing.
• CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or
sensitive nish. As with any rubber compound made with oils, the feet could cause marks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
• WARNING: Shock hazard - Do Not Open.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
• Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
• WARNING: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD. If you think batteries
might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• Do not mix old and new batteries.
• Completely replace all old batteries with new ones.
• Batteries should be recycled or disposed of as per state and local guidelines.
• WARNING: This product may contain chemicals known to the State of California to cause birth
defects, or other reproductive harm (California Prop 65). Wash hands after handling.
• This product meets and complies with all Federal regulations.
Orientation
Clock Radio with Dual Alarm
User’s Guide for Model C336 v1566-01
Features
• 1.8” green LED display with digital clock
• Dual alarm
• Wake to alarm or radio
• Sleep timer
• Snooze
• Digital AM/FM radio (PLL)
with built-in antennas
• Radio station presets (10 FM/10 AM)
• Built-In speaker
• Digital volume control
• Aux in (3.5mm audio input)
• AC power: built-in AC power adapter
• Battery backup: requires 2 AAA batteries
for clock and last user settings
Clock/Mem
In Off mode, press
and hold to begin
setting the time.
In radio mode, press
to cycle through
preset stations.
Power/Source/
ALM O
Press to turn the unit on.
Press and hold to
turn off the radio.
Press to turn
off the alarm.
Press repeatedly to
select AM, FM or Aux.
Snooze/Sleep
Press to snooze the alarm after it sounds.
Press repeatedly to set the sleep timer.
Alarm 1: Buzzer/
Radio Indicator
Indicates alarm 1 is
set to buzzer or radio.
Alarm 2: Buzzer/
Radio Indicator
Indicates alarm 2 is
set to buzzer or radio.
Volume/ALM2/ALM1
Press to adjust
the volume.
Press and hold to begin
setting Alarm 1 or Alarm 2.
PM Indicator
Lights when the
time is in the PM.
Sleep Indicator
Lights when the
Sleep Timer is ON.
LED Display
Dimmer
Press to dim the display.
Tuning/Min/Hour
Press to tune the radio.
Press to adjust the minute
or hour when setting the
clock or alarm.
To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:
www.iLiveElectronics.com
Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección
de apoyo en: www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des questions fréquemment
posées, consultez la rubrique d’assistance sur: www.iLiveElectronics.com
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com
Customer Service: 1-888-999-4215 | Email Support: [email protected] | Email Parts: par[email protected]
Copyright © 2016 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective
owners. Specications are subject to change without notice.
International Support
Protect for Today
Sustain for Tomorrow
Made
Green
Setting the Alarm
1. If in radio mode, press and hold the Power/Source/ALM OFF button to turn
the unit o.
2. Press and hold the ALM1 or ALM2 button until the display begins to blink.
3. Press the Hour button to set the hour. The PM indicator will light when the
hour is set in the PM.
4. Press the Min button to set the minutes.
5. Press the ALM1 or ALM2 buttons repeatedly to select Radio, Buzzer, or
Alarm OFF.
6. Once the set alarm time is reached, the alarm will sound.
7. To set the other alarm, follow the above steps and choose the alarm not
currently set.
An AM/FM antenna is built into the clock radio. To improve radio reception, adjust
the position of the clock radio.
Tuning the AM or FM Radio
1. Press the Power/Source/ALM OFF button to turn the clock radio on.
2. Press the Power/Source/ALM OFF button again to select AM, FM or Aux In.
3. Press the Tun+/− buttons to adjust the radio to the desired frequency.
4. Press and hold the Tun +/− buttons to search for the next available
frequency.
5. Press the Vol+/− buttons to adjust the volume.
6. Press and hold the Power/Source/Al O to turn the radio o.
Clock & Sleep Timer
Alarm
Radio
Setting the Clock
1. If in radio mode, press and hold the Power/Source/ALM OFF button to
turn the unit o.
2. Press and hold the Clock/Mem button until the display begins to blink,
then release the button.
3. Press the Hour button to set the hour. The PM indicator will light when the
hour is set in the PM.
4. Press the Min button to set minutes.
5. Press the Clock/Mem button to nish setting the time.
Setting the Sleep Timer
1. Press the Snooze/Sleep button repeatedly to set the sleep timer
( 90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF ).
2. Once the set sleep time has expired the clock radio will automatically
power o.
Disabling the Alarm
1. Press the ALM1 or ALM2 buttons until the indicator is no longer lit.
Snooze and Alarm Reset
After the alarm sounds:
Press the Snooze/Sleep button to delay the alarm for an additional 9 minutes.
OR
Press the Power/Source/ALM OFF button to turn the alarm o
until the set alarm time is reached again.
Saving Radio Presets
1. Tune to the desired station.
2. Press and hold the Clock/Mem button to save the current radio
station as a preset.
3. Press the Tun +/− buttons to select the preset (P01-P10) to be saved.
4. Press the Clock/Mem button to cycle through radio presets.
Aux In
Power & Battery
Requires a 3.5 mm audio input cable (not included).
1. Plug a 3.5 mm audio input cable into the Aux In input on the rear of the
unit and an audio output/headphone jack on an MP3 Player or phone.
2. Press the Power/Source/Al O button to power ON the clock radio.
3. Press the Power/Source/Al O to set the source to Aux.
4. Audio played through the connected device should now be heard through
the speakers.
Requires 2 AAA batteries (not included). Batteries are used to power the
clock and save user settings if no AC power is present.
To power the unit, plug the power cord on the back of the unit into a
standard AC power outlet.
Other GPX Clock Radio manuals
