Denver CRQ-105 User manual

Quick start guide
Connecting power: Connect the included Micro
USB cable to the Micro USB port on the backside of the main unit.
Your clock has a battery backup feature, Place 2 x batteries into the
compartment.
Radio:
1. Press Touch Button Lock on the backside of the unit to unlock the
touch button.
2. Press the “ /R DIO/ L OFF” to turn the radio on, and press the
“HOUR/TUN-“ or “MIN/TUN+” button to adjust frequency.
3. Press and hold “TIME/PRESET” button until “P01” (or the next
available preset) shows on the display.
4. Press the “HOUR/TUN-“ or “MIN/TUN+” button to select a preset
number (P01-P10), then press the “TIME/PRESET” button to
confirm.
5. Press the “TIME/PRESET” button repeatedly while listening to the
radio to select a preset station.
6. Press Touch Button Lock on the backside of the unit to lock the
touch button.
SETTING THE TIME
1. Press Touch Button Lock on the backside of the unit to unlock the
touch button.
2. In standby mode, press and hold the “TIME/PRESET” button to enter
the clock setting mode.
3. Press the “HOUR/TUN-“ and “MIN/TUN+” to select hours and minute,
then press “TIME/PRESET” button to confirm.
4. Press Touch Button Lock on the backside of the backside of the unit to
lock the touch button.

SETTING THE ALARM
1. Press Touch Button Lock on the backside of the unit to unlock the
touch button.
2. In standby mode, press and hold the “ L1/VOL-“ or “ L2/VOL+”
button to enter the alarm time setting mode.
3. Press “HOUR/TUN-“ to set the hour and “MIN/TUN+” button to set
the minute then press “ L1/VOL-“ or “ L2/VOL+” button to confirm.
4. Press Touch Button Lock on the backside of the unit to lock the touch
button.
QI WIRELESS CHARING
1. Place your Qi enabled smartphone on the center of the wireless
charging pad. The Wireless Charging Indicator on display will be on.
2. Please check if your phone screen shows charging status
If your phone is not charging;
-Check if your device supports Qi wireless charging
-Place mobile device in center
-Remove the case with magnet, metal, or thicker material than
0.12”(3mm)