GPX CC319B User manual

CUSTOMER HELPLINE | 1-314-621-2881 GPX | CC319B
WARNINGS & PRECAUTIONS
FCC WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
INTRODUCTION
USER’S GUIDE
V:1615-0520-09
CC319B
CD Clock Radio with Dual Alarms
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
• WARNING:Topreventreorshockhazards,donotexposethisunitto
rain or moisture.
• CAUTION: Use of controls or adjustments or performance of procedures
otherthanthosespeciedmayresultinhazardousradiationexposure.
• WARNING:Changesormodicationstothisunitnotexpresslyapproved
bythepartyresponsibleforcompliancecouldvoidtheuser’sauthorityto
operate the equipment.
• WARNING:Donotplacetheunitontopofanysoft,porous,orsensitive
surfaces to avoid damaging the surface. Use a protective barrier between
the unit and surface to protect the surface.
• CAUTION: Dangerofexplosionifbatteryisincorrectlyreplaced.Re-
placeonlywiththesameorequivalenttype.
• PRÉCAUTION: Danger d’explosion si les piles sont remplacées de fa-
çon incorrect. Remplacer les piles seulement par le même type de pile ou
l’équivalent.
Donotmixoldandnewbatteries.
Donotmixalkaline,standard(carbon-zinc),orrechargeable(ni-cad,ni-
mh,etc)batteries.
No mezcle baterías viejas y nuevas.
No mezcle baterías alcalinas, estándar (carbono-zinc) o recargables (ni-
cad, ni-mh, etc.).
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Cleanonlywithadrycloth.
7. Donotblockanyventilationopenings.Installinaccordancewiththe
manufacturer’s instructions.
8. Donotinstallnearanyheatsourcessuchasradiators,heatregisters,
stoves,orotherapparatus(includingampliers)thatproduceheat.
9. Donotdefeatthesafetypurposeofthepolarizedorgrounding-type
plug.Apolarizedplughastwobladeswithonewiderthantheother.A
groundingtypeplughastwobladesandathirdgroundingprong.The
widebladeorthethirdprongareprovidedforyoursafety.Whenthe
providedplugdoesnottintoyouroutlet,consultanelectricianfor
replacement of the obsolete outlet.
10.Protectthepowercordfrombeingwalkedonorpinchedparticularlyat
plugs,conveniencereceptacles,andthepointwheretheyexitfromthe
apparatus.
11. Onlyuseattachments/accessoriesspeciedbythemanufacturer.
12.Use only with a cart, stand, tripod,
bracket,ortablespeciedbythe
manufacturer, or sold with the
apparatus. When a cart is used,
usecautionwhenmovingthecart/
apparatus combination to avoid
injuryfromtip-over.
13.Unplug this apparatus during lightning storms or when unused for long
periods of time.
14.Referallservicingtoqualiedservicepersonnel.Servicingisrequired
whentheapparatushasbeendamagedinanyway,suchaspower-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into
theapparatus,theapparatushasbeenexposedtorainormoisture,does
notoperatenormally,orhasbeendropped.
Theexclamationpointwithinanequilateraltriangle
is intended to alert the user to the presence of
importantoperatingandmaintenance(servicing)
instructionsintheliteratureaccompanyingthe
appliance.
Thelightningashwitharrowheadsymbol,within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous voltage"
withintheproduct'senclosurethatmaybeof
sufcientmagnitudetoconstituteariskofelectric
shock to persons.
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(ORBACK).NOUSER-SERVICEABLEPARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CD Door
Open and close to load or
unload a CD.
AL1 (Alarm 1)
Press to view and set alarm 1.
AL2 (Alarm 2)
Press to view and set alarm 2.
Sleep
Press to set the sleep timer.
Snooze
Presstodelaythealarmforan
additional 9 minutes after it has
sounded.
CLK Set
Press to adjust the hour and
minute when setting the clock
or alarms.
Dimmer
Use to adjust the brightness of
thedisplay.
Tuning
Turn to adjust the AM or FM
radiofrequency.
Buzz/Radio/CD
Use to adjust the source to
Radio or CD, or to adjust the
alarmsourcetoBuzzer,Radio,
or CD.
Volume
Turn to adjust the volume.
AM/FM ST.
Use to adjust the radio mode to
AM or FM.
Backup Battery
Compartment
Requiresone9voltbattery(not
included).
Power
Press to turn the unit off and on.
Random/CLK ADJ
With the clock radio powered
off, press to set the clock.
In CD mode,presstoplay
tracks from the loaded CD in a
random order.
Play/Pause
Presstoplayorpausethe
loaded CD.
Skip/Search
Press to Skip to the previous or
nexttrack.
Press and hold to rewind or
fast-forward within a single
track.
Stop
Press to stop the CD.
Repeat
Press to repeat the current track.
The Repeat Indicator Light will
blink when the clock radio is set
to repeat a single track.
While set to repeat a single
track, press to repeat the entire
CD.
The Repeat Indicator Light
will illuminate solid when the
clock radio is set to repeat the
entire CD.
NOTE:Thisequipmenthasbeentestedandfoundtocomplywiththelimits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses, and can
radiateradiofrequencyenergyand,ifnotinstalledandusedinaccordance
withtheinstructions,maycauseharmfulinterferencetoradiocommunica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radioortelevisionreception,whichcanbedeterminedbyturningtheequip-
mentoffandon,theuserisencouragedtotrytocorrecttheinterferenceby
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

CUSTOMER HELPLINE | 1-314-621-2881 GPX | CC319B
Setting the ClockAC Power Battery Backup
Tuning the AM or FM Radio
Playing a CD Playback Features
Improving Radio Reception Setting the Alarm Time
Choosing an Alarm Source
Activating the Set Alarm
Gradual Wake - What does it mean?
Whenever the alarm sounds on the unit, the
volume level will start low and gradually rise
until it reaches the level set on the Volume dial.
This makes for a considerably less abrupt wake-
up call in the morning.
Setting the Sleep Timer
BASIC OPERATIONS
USING THE ALARMSUSING THE AM OR FM RADIO
POWERING THE UNIT
USING THE BUILT IN CD PLAYER
Press the POWER button to turn the clock radio o.
The Power Indicator Light will go out when the clock radio
is powered o.
Press and hold the CLOCK ADJUST button for 3-5
seconds.
The hour on the clock will begin to blink.
Press the CLOCK SET buttons to adjust the hour.
Press the CLOCK ADJUST button.
The minute on the clock will begin to blink.
Press the CLOCK SET buttons to adjust the minute.
Press the CLOCK ADJUST button to nish setting the
clock.
Plug the attached AC cord into a standard AC outlet to
power the unit.
Requires one 9 volt battery (not included).
Connect a 9 volt battery to the battery leads inside of the
battery compartment on the bottom of the unit to power
the battery backup.
The battery backup is meant for short term power loss
only. The clock and alarm settings are the only settings
retained in the event of a short term power loss. The radio
and CD player will not work when the unit is powered
solely by the battery backup.
Press the POWER button to turn the clock radio on.
The Power Indicator Light will illuminate when the clock
radio is powered on.
Adjust the BUZZ/RADIO/CD switch to Radio.
Adjust the AM/FM ST. switch to the desired radio band.
Turn the TUNING dial to adjust the AM or FM radio
frequency.
Press the POWER button to turn the clock radio on.
The Power Indicator Light will illuminate when the clock
radio is powered on.
Adjust the BUZZ/RADIO/CD switch to CD.
Open the CD DOOR, load a CD into the clock radio, and
close the CD DOOR.
The CD needs to be loaded with the label-side facing up.
Press the PLAY/PAUSE button to begin playing the
loaded CD.
Play/Pause
Press to Play or Pause the CD.
Skip/Search
Press to Skip to the previous or next track.
Press and hold to rewind or fast-forward within a single
track.
Stop
Press to Stop the CD.
Repeat
Press to repeat the current track.
The Repeat Indicator Light will blink when the clock radio is
set to repeat a single track.
While set to repeat a single track, press to repeat the entire
CD.
The Repeat Indicator Light will illuminate solid when the
clock radio is set to repeat the entire CD.
Random
Press to play tracks in a random order.
Adjust the attached FM Wire Antenna to improve FM radio
reception to the clock radio.
An AM Antenna is built into the clock radio. Adjust the
position of the clock radio to improve AM radio reception.
Press the POWER button to turn the clock radio o.
The Power Indicator Light will go out when the clock radio
is powered o.
Press the AL1 or AL2 button to display the alarm 1 or
alarm 2 time.
Press and hold the AL1 or AL2 button for 3-5 seconds.
The hour on the alarm time will begin to blink.
Press the CLOCK SET buttons to adjust the alarm hour.
Press the AL1 or AL2 button.
The minute on the alarm time will begin to blink.
Press the CLOCK SET buttons to adjust the alarm minute.
Press the AL1 or AL2 button to nish setting the alarm
time.
After the alarm time is set, adjust the BUZZ/RADIO/CD
switch to the desired source.
Adjust the VOLUME dial to the desired level.
When the set and active alarm time is reached, the unit will
power on to the selected source.
Press the Power button to turn the clock radio o.
The Power Indicator Light will go out when the clock radio
is powered o.
Press and hold the AL1 button for 3-5 seconds to activate
or deactivate alarm 1.
The AL1 Indicator will illuminate when alarm 1 is activated.
Press and hold the AL2 button for 3-5 seconds to activate
or deactivate alarm 2.
The AL2 Indicator will illuminate when alarm 2 is activated.
Press the SLEEP button repeatedly until the desired
amount of time is reached.
Once the designated time expires, the clock radio will
power o.
FM
AM