GPX CC318 v2083-01 User manual
Important Safety Instructions
• Read these Instructions.
• Keep these Instructions.
• Heed all Warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliers) that
produce heat.
• Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong
are provided for your safety. When the provided plug does not t into your outlet, consult an electrician for replacement
of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
• Only use attachments/accessories specied by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS AND PRECAUTIONS
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• Mains plug is used as disconnect device and it should remain readily operable during intended use. In
order to disconnect the apparatus from the mains completely, the mains plug should be disconnected
form the mains socket outlet completely.
• Caution marking is located at the rear or bottom of the apparatus.
• WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain, moisture,
dripping, or splashing.
• CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or
sensitive nish. As with any rubber compound made with oils, the feet could cause marks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
• WARNING: Shock hazard - Do Not Open.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
• Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
• WARNING: DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD. If you think batteries
might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• If the coin/button cell battery supplied with this product is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
• Completely replace all old batteries with new ones.
• Batteries should be recycled or disposed of as per state and local guidelines.
Overview
CD Clock Radio
User’s Guide for Model CC318 v2083-01
Sleep
Press repeatedly to set
the sleep timer.
Alarm 1 & 2
Indicator
Aux In
(3.5mm Audio Input)
Program
Indicator
(CD MODE)
PM Indicator
Repeat Play
Indicator
(CD MODE)
Power
ON/OFF
Indicator
Random Play
Indicator
(CD MODE)
Sleep Alarm
Indicator
WARNING : This product can expose you to chemicals including lead, which is known
to the State of California to cause cancer and birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov. This product meets and complies
with all Federal regulations.
Stop/Time
Press to stop a CD during play.
In O mode, press and hold to
begin setting the time, then use
the Skip/Search buttons to set
the minutes and hours.
AL1/AL2
Press & hold to begin
setting Alarm 1 or Alarm 2.
Volume
Source
Press to switch between
Radio and CD modes.
Power
Press to turn the unit
ON or OFF.
Prog
Press to set a program to
play tracks in a certain
order in CD mode.
Play/Pause
Press to play or pause
a loaded CD.
Skip/Search/Tune +/-
Press to skip between tracks on a
loaded CD. Press and hold search
through the current track.
In Radio mode, press to tune the
radio. Press and hold to search for
the next available station.
Snooze
Press to delay the alarm
for several minutes.
Dimmer
Press to adjust the
brightness of the display.
Play Mode/Display
Press to switch between Repeat 1,
Repeat All, and Random (CD MODE).
Press and hold to display track
number or station.
To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:
www.gpx.com
Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección
de apoyo en: www.gpx.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des questions fréquemment
posées, consultez la rubrique d’assistance sur: www.gpx.com
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com
Customer Service: 1-888-999-4215 | Email Support: [email protected] | Email Parts: par[email protected]
Copyright © 2018 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective
owners. Specications are subject to change without notice.
International Support
Protect for Today
Sustain for Tomorrow
Made
Green
Saving Radio Presets
1. Tune to the desired AM or FM frequency (see above steps).
2. Press and hold the Prog button. The display will begin ashing a preset. Ex: "P01".
3. Press the buttons to select the preset to be saved. (P01 to P23).
4. Press the Prog button to save that preset.
5. With the radio ON, press the Play button to cycle through radio presets.
Power and Batteries
Requires 2 AA, 1.5V batteries (not included).
Plug the AC power cord into a standard power outlet.
Clock
Setting the Clock
1. With the unit OFF, press and hold the Stop/Time button until the display ashes.
2. Press the buttons to adjust the hour. Note the PM indicator on the display.
3. Press the Stop/Time button to set.
4. Press the buttons to adjust the minute.
5. Press the Stop/Time button to nish setting the time.
Alarm and Sleep Timer
Setting the Alarm
1. With the unit OFF, press and hold the AL1 or AL2 button until the display ashes.
2. Press the buttons to select CD, buzzer (bb), or the radio.
3. Press the AL1 or AL2 button.
4. If using the radio, press the buttons to adjust the radio frequency.
If using the CD player, press the buttons to select the CD track. Be sure a CD is
loaded in the unit.
5. Press the AL1 or AL2 button.
6. Press the buttons to adjust the hour. Note the PM indicator on the display.
7. Press the Stop/Time button to set.
8. Press the buttons to adjust the minute.
9. Press the Stop/Time button to nish setting the alarm time.
10. Use the Volume dial to set the volume of the alarm, except when set to Buzzer.
11. Once the set alarm time is reached, the alarm will sound. To set the other alarm, follow
the above steps and choose the alarm not currently set.
Snooze and Alarm Reset
After the alarm sounds:
Press the Snooze button to delay the alarm for several minutes.
OR
Press the Power button to turn the alarm o until the set alarm
time is reached again.
Disabling the Alarm
Press the AL1 or AL2 buttons to turn the alarm ON or OFF.
FM Radio
Radio Reception
An FM antenna is built into the clock radio. To improve radio reception, adjust the position of
the clock radio.
Tuning the FM Radio
1. Press the Power button to turn the unit on.
2. Press the Source button to switch to Radio mode, then press the buttons to
select the desired frequency, or press and hold to scan for the next available frequency.
CD Player
Note: This unit is not compatible with MP3 CDs.
Loading and Playing a CD
1. Open the CD Door.
2. Place a CD into the unit, label side facing up.
3. Close the CD Door.
4. Press the Source button to switch to CD mode.
5. Press the Play/Pause button to begin playing the loaded CD. Press the
buttons to skip tracks or press and hold to search through a track.
Programming a CD
1. Press the Stop button to stop the CD during play.
2. Press the Prog button, “P01” will begin to show on the display.
3. Press the buttons to select a track.
4. Press the Prog button to save the selected track to the program. Repeat this step to
program up to 20 tracks.
5. When you are nished programming, press the Play button to begin your program. The
Prog Indicator will light on the display.
6. Press Stop to stop playing. Press Stop again to cancel the program, the Prog indicator
on the display will turn OFF.
Aux In
Using the Audio Input
Requires a 3.5mm audio cable (not included).
1. With the unit powered ON, connect a 3.5mm audio cable to the Aux In on the rear of
the unit and the audio output on an audio device. The unit will automatically detect
the connection and switch to AUX mode.
2. Use the controls on the connected device to play your audio through the unit. Use the
Volume dial to adjust the volume.
Setting the Sleep Timer
1. Press the Sleep button to set the sleep timer (90, 60, 30, 15 min or OFF).
2. Once the set sleep time has expired the clock radio will automatically power o.
Table of contents
Other GPX Clock Radio manuals
