Customer Support: 1-888-999-4215GPX | TD930
Quickstart Guide
Before the TV/DVD player can
begin receiving television
channels, a scan for available
channels must be run.
1. Connect an RF antenna or
cable TV source to the TV/
DVD player.
2. Adjust the POWER SWITCH
on the TV/DVD player to the
ON position.
3. Press the SOURCE button
repeatedly to select TV
mode. Press the ENTER
button.
4. Press the SCAN button on
TV/DVD player.
5. Press the VOLUME buttons
to switch between AIR and
CATV.
Select AIR if you have an RF
antenna connected to the
TV/DVD player.
Select CATV if you have a
cable TV source connected
to the TV/DVD player.
6. Press the ENTER button.
7. The TV/DVD player will
now automatically begin
scanning for available
channels. This process can
take several minutes to
complete.
To exit the Auto-Scan before
it has completed, press the TV
MENU button on the remote.
Television Setup
Watching Television
Before watching television, you
must connect an RF ANTENNA
(included) or a cable TV source,
and following the instructions
for Auto-Scanning for Channels.
1. Adjust the POWER SWITCH
on the TV/DVD player to the
ON position.
2. Press the SOURCE button
repeatedly to select TV
mode. Press the ENTER
button.
3. Press the CHANNEL buttons
to change the channel and
watch television.
Auto-Scanning for Channels
Connecting the RF Antenna
Connect the included RF
antenna to the RF INPUT on the
TV/DVD player.
OFF/ON
DC IN
9-12V SD/MMC CARD USB
RF IN
Connecting a Cable TV Source
Connect the cable TV source to
the RF INPUT on the TV/DVD
player.
OFF/ON
DC IN
9-12V SD/MMC CARD USB
RF IN
