NOTE: IF disruption should occur (signal breaks up), press the “SCAN”
n the channels on
es of
. Ou , Water Use & Weather Conditions
be used in conservative outdoor
should not be operated in extreme temperature
of water body
ARNING: The power adaptor included with your unit is intended for indoor
auto-tuning button on the speaker to maximize best reception.
f you hear interference from other components, switch betweeI
the transmitter and press the “SCAN” auto-tuning button for best reception.
NOTE: batteries should be removed from the transmitter & speaker in cas
extended storage periods. Move the speakers indoors when weather conditions
are extreme.
tdoor6
ÎSchooners II speaker is designed to
conditions
The speakerÎ
The transmitter and adapters must NOT be used in any typeÎor in a moist or wet environment.
W
environments and use. Do NOT use the power adapter in moist or wet
environments. Where there is a chance of rain, you may operate the speaker with
battery power.
TROUBLE SHOOTING
t the batteries are fully charges on the speaker aker grill. Turn
r
nect the AC/DC adaptor to the speaker.
ISTORTED SOUND
Press the “AUTO-TUNE” button on the speakers to find the transmitter frequency
O
closer. source volume
O SOUNDN
Check tha-
- Check there is not too much water retention inside the spe
over the speaker and let the water drain out from the speaker grill.
- E powensure the AC/DC adaptor is fully inserted into theAC outlet and the
connection input on the transmitter.
E- nsure the speaker is switch ON. on- Speaker’s battery capacity is low, c
- Ensure the TV or audio component is ON. e volume to an appropriate level.- The volume of speaker is too low, adjust th
D
-
- Check there is not Too much water retention inside the speaker grill. Turn
over the speaker and let the water drain out from the speaker grill.
- C s “AUThange the position of the channel selector on the transmitter. Pres
TUNE” button on the speaker.
E aker is adjusted properly.- nsure the volume level of spe
- The speaker is too far away from the transmitter, move it
- Audio input level of the audio signal is too low. Turn up the audio
- The Transmitters audio input level is too high, lower the audio source volume level
- Ideally the audio source is ON and volume level is set to at 50-75% of maximum.
P.6
