Grand PATIO BRETON User manual

BRETON COFFEE TABLE

Made in China
ASSEMBLY INSTRUCTIONS
IMPORTANT: Please read and understand this manual before any assembly.
Before beginning assembly of product, make sure all parts are present. Compare
parts with packaging contents list. If any part is missing, please contact us.

3
TABLE OF CONTENTSIMPORTANT SAFETY INSTRUCTIONS
Important Safety Instructions 3
Parts List 4
Assembly 5
Cleaning and Maintenance 8
Technical Data 8
IMPORTANT: Retain for future reference, and read carefully.
Warning! To reduce the risk of serious injury, read the following safety
instructions before assembling and using the table.
•
This product is intended for domestic outdoor use only.
•
The product should be placed on flat, horizontal ground.
•
Any assembly or maintenance of the product must be carried out by adults only.
•
Arrange necessary manpower when assembling or moving the product.
•
Some parts may contain sharp edges. Wear protective gloves if necessary.
•
Keep children and pets away while setting up the table.
•
Check all nuts and bolts periodically for tightness. When required, tighten them again.
•
Repairing and replacing parts should be done by a qualified technician.
•
If the product will not be used for a long period (e.g., winter time), it should be stored in a clean,
dry environment.
•
Do not light any fires below or near the product!
•
Retain the original packaging to store the table.
Caution! Always keep children under close supervision while they are using or around
this product.
Never leave children unattended.

Table top - 1 Screw with washer M6X15 - 10
Leg - 2
Connecting bar - 1
1
2
3
Hex key - 1
B
A
4
PARTS LIST

Hex key
5
ASSEMBLY PREPARATION
CAUTION!
•
The maximum load for coffee table is 44 lb (20 kg).
Do not stand on the product.
•
Keep children away during assembly.
This product contains small parts which can be swallowed by children.
•
Keep fingers away from the places where they can be pinched or trapped.
•
Do not attempt to assemble the table if any parts are missing.
Needed for assembly:
Place all parts from the box in a cleared area and position the m on the floor in front of you.
Remove all packing materials and place them back into the box. Do not dispose of the packing
materials until assembly is complete. Read each step carefully before beginning any assembly
and make sure you understand each step.
.

Step 1
Requires part 1, 2, A, B
Attach the table legs 2to the table top 1using the screws Awith washers,
aligning the holes. When assembled, tighten the screws with the hex key B.
Step 2
Requires parts 2, 3, A, B
Connect two table legs 2with the connecting bar 3using the screws Awith washers,
aligning the holes. When assembled, tighten the screws with the hex key B.
4
6
ASSEMBLY
Note: Do not tighten screws all the way until you have assembled the table.
Once assembly is complete, tighten each screw.
2
1
3
2
A
A

Step 3
Turn the table to the upright position.
7
ASSEMBLY

8
CLEANING AND MAINTENANCETECHNICAL DATA
12 PRODUCT NO. 046-3456-8 | MODEL NO. 088-163
•
Clean the product with a slightly damp cloth and a little detergent. Let it dry thoroughly.
•
Do not use bleach, acid, or other abrasive cleaners on the table or frame parts.
CAUTION!
•
Check all screws and nuts periodically for tightness, tightening them
again as required.
Dimensions (L x W x H)
Product weight
19 3/32 x 33 1/16 x 18 1/8"
48.5 x 84 x 46 cm
23 lb 2 oz (10.5 kg)