Grandview 6939982391070 User manual

Installation Guide for
Sheet Metal Extension Bracket
Thank you for purchasing a Grandview projection screen.
Before use, please read instructions carefully.
After installation, store instructions for future reference.
To assure safety, please make sure the wall to be installed on
can bear a weight twice heavy as the weight of the screen.
Dimensions
Caution:
Distribution:
PureLink GmbH Available from B2B Online Portal

Installation Kit
Horizontal & vertical
bar joint(2 sets)
Inclined bar(2pcs) 5x40mm self-tapping screws
and swell plastic button(4sets)
M5x38mm screws(2pcs) M5x42mm screws(2pcs)
M5x30mm screw
M6x30mm screw
(4pcs of each)
M5 anti-skid nut and gasket
M6 anti-skid nut and gasket
(4pcs of each)
Installation Guide
1. Take out the horizontal & vertical bar joint first and make a right angle,
refer to diagram 1.
2. Install the M5x42mm screws to the vertical bar, refer to diagram 2.
3. No need to install M5x38mm screws first, refer to diagram 3.
Diagram 1 Diagram 2 Diagram 3
5 Gasket
M5x42mm
Screw
5 Gasket
M5x38mm
Screw
Installation Guide
4. Install the extension bracket to the wall and make sure it is firm enough, refer
to diagram 4 left side.
Install the M5x38mm screw on the horizontal bar, fasten all the screws, refer
to diagram 4 right side.
Wall 5 Gasket
M5x38mm
Screw
5x40mm self-tapping screw
and swell plastic button
After installing the vertical
bar to the wall fasten the
screw on the horizontal bar.
Diagram 4
5. Install the installation bracket to the extension bracket
Wall
Screw
Gaskets
Anti-skid nut
Installation bracket
(Not in the same package)
Diagram 5
5 Gasket(6pcs)
Distribution:
PureLink GmbH Available from B2B Online Portal