Granite SIGNATURE User manual

1
Signature Stage Deck Instructions

2
Site Preparation
-Determine the exact location where the stage will be erected.
-For outdoor stages, mudsills are required to distribute the weight of 125psf on the
stage legs. This will prevent the legs from sinking and ease the leveling of the
stage.
-All base pads and mudsills should be placed only on a horizontal surface.
Leg Assembly
-The leg sockets on the stage sections fit 1-3/4” square stage legs

3
Setting the Stage
-Insert legs completely into all four corner sockets on first stage section and tighten
thumb screw which holds leg into deck.

4
Setting the Stage continued
-
Set first section in back left-hand corner of stage area. Note: any corner may be used
as s starting point. (the first deck is referred to as the starter deck)
-Align the stage section so that the connecting fingers are to the inside and the smooth
sides are to the outside of the stage area.
-Set back row of stages first.
-Insert two legs into stage sections as you work your way along the back row, attaching
each deck to the previous one back setting them together using the connecting fingers.
-Upon completion of the back row, begin the second row with one section with two legs.
-To continue the second row, insert one leg into corner socket, then set the deck into
the connecting fingers onto both deck.

5
Locking Stage Decks Together

6
Diagonal Bracing

7
Diagonal Bracing
Top View

12
Stair Handrail

13
Stair Installation